diy rotational molding machine

... are installed inside the frame, and the installation and wiring are simple without leakage, PI65Dustproof and waterproof. The new folding part ado...

..., greatly increased the space utilization and blowing tube effect 2. Built-in many sets of operating procedures can be convenient and flexible call...

1. Product introduction Flexible Dual capacity control: switch between 4-stage and seamless capacity control – with no compressor adaptation work Suct...

... High Precision With 7" Touch Panel Model: RS-8105A-5 Purpose: The tester is suitable for the bending testing of the multi-wires cable, comm...

... method is: fix one end of the earphone on the torsion clamp and fix headband on the support frame, then set test angle and speed. After c...

... cable, earphone cable etc. Cables flexible testing method is short –circuit connecting one end cable and fix this end on the plate, and p...

... products and the hinges. Can measure the torsion of positive and reverse , and have the software to create the curves of testing,...

... Model: C5092 Purpose: Cable swing test is suitable for the bending testing of the multi-wires cable, communication cable, earphone ...

... Wire Swing Left And Right Tester Model: C5092 Purpose: Cable bending cycle test is suitable for the bending testing of the multi-wi...

... Bending Endurance Test Adjustable Model: RS-8100 Application: Apply for bending endurance test for cable connected with plug. Fix the sampl...

... and signal cables. Test methods: make one end of the cable short connected and clamped, fix it on a disk, and then make it lateral...

.../Cable Testing Equipment for Headphone Line or USB Line Model: RS-8116-6B Purpose: It is suitable for bending resistance test on headphone c...

... products and the hinges. Can measure the torsion of positive and reverse , and have the software to create the curves of testing,...

... conductor, flat cable and signal line, etc. The test method is as follows: Firstly, clamp one end of the wire rod and fasten it to the cl...

... electronic products. The working principle is to place the product to be tested in a drum, and then let the drum continue to , so t...

Botttle Drop Impact Resistance of Blow- Thermoplastic Containers Bottle Drop Impact Resistance Testing Model: DT2200 Purpose: Free Drop ...

Appliance Electrical Phase Tester Equipment Resistance Model: RS-8119 Application: This is mainly used for the resi...

... / Laptop Torque Testing Equipment Model: RS-6300D Purpose: Apply for the torque test of Note-book hinge, mobile hinge /full unit, electroni...

... cable, earphone cable etc. Cables bending resistance testing method is short –circuit connecting one end cable and fix this end on the pl...

... to do bending test. Test method is: short-circuit clamping one end of wire and fastening it on the rotary disc, leaving it right and left...