12m/Min C Z Purlin Roll Forming Machine , 12Mpa Cold Roll Forming Equipment

Fully Automatic Galvanized Steel Sheet CZ Cold Roll Forming Machine

Usage and introduction:

The Cz Shaped Purlin Roll Form Machine adopts a cast iron structure. The driving way is chain driving. The size will be adjusted by the spacers between the rollers. The cutting is after forming, so the cutting position will be very smooth. There are two punching holes at the two sides of the cutting position.

Quick C to Z interchange:

The rollers for C & Z are changed very quickly without dismantling any parts, The forming tooling is simply unclamped (two bolts), rotated through 180 degrees, and re-tightened. No tooling or spacers are removed or changed. Quick, Easy, Simple.

Size change:

The form tooling is unclamped, slid into the correct position by PLC control. No special tools, no spacer changed. Infinite sizes are possible. Only input data in the touch screen can adjust any size automatically, by motor driving stations moving accurately on linear guide rail with encoder.

Technical parameter

All the technical parameters are also made as per the customers' requirements.

Features:

punching is added to the flying saw cutting part, by the hydraulic control, mainly in the red c-shaped steel in the hole based, can be set up according to their needs, can be washed from time to punch, simple to use.

Punching and Cutting:

1. punching mold: Cr12 HRC 58-62

2. machine with 2 sets punching system according to punching drawing

3. Punching with hydraulic drive

4. punching at end-wise controlled by PLC control system, punching at broad-wise adjusted by manual

5. Punch details drawing, end-user has to provide.

6. Hydraulic Cutting before forming: Cut the sheet before roll forming to the required length

7. Cutting motion: The main machine automatically stops, then punching and cutting.

8. The material of blade: CR12with heat treatment

9. Length measuring: Automatic length measuring

10. Tolerance of length: 3m+/- 1.5mm

Control panel

1. Voltage, Frequency, Phase: 415V, 50 Hz, 3Phase or customized

2. Automatic length measurement:

3. Automatic quantity measurement

4. A computer used to control length & quantity. The machine will automatically cut to length and stop when the required quantity is achieved

5. Length inaccuracy can be amended easily.

6. Control panel: Button-type switch and touch screen

7. Unit of length: millimeter (switched on the control panel)

8. The program should be can set 5 different measures and quantities.

Discharge machine
1. Load: 5 tons

2. Tightening method: hand crank. The center of the four links is outwardly supported
3. Brake: Spindle double hold tight

Feeding table
1. Feeding length: 3 meters 2 pieces
2. Feeding method: the frame body is welded with angle steel and angle steel, and the surface is loaded with rollers.

Product detail drawing

Wuxi Hengruiyang Technology Co., Ltd is a manufacturer of roll forming machine. At present, our products have been exported all over the world, and maintained good cooperative relations with customers.