

Add to Cart
LM2700MTX-ADJ/NOPB Switching Voltage Regulators PMIC Power Management ICs SN75LVCP601RTJR W25Q128JVFIQ Power Management
Detailed Description
The LM2700 utilizes a PWM control scheme to regulate the output
voltage over all load conditions. The operation
can best be understood referring to the block diagram and Figure 17
of the Operation section. At the start of
each cycle, the oscillator sets the driver logic and turns on the
NMOS power device conducting current through
the inductor, cycle 1 of Figure 17(a). During this cycle, the
voltage at the VC pin controls the peak inductor
current. The VC voltage will increase with larger loads and
decrease with smaller. This voltage is compared with
the summation of the SW voltage and the ramp compensation. The ramp
compensation is used in PWM
architectures to eliminate the sub-harmonic oscillations that occur
during duty cycles greater than 50%. Once the
summation of the ramp compensation and switch voltage equals the VC
voltage, the PWM comparator resets the
driver logic turning off the NMOS power device. The inductor
current then flows through the schottky diode to the
load and output capacitor, cycle 2 of Figure 17(b). The NMOS power
device is then set by the oscillator at the
end of the period and current flows through the inductor once
again.
The LM2700 has dedicated protection circuitry running during normal
operation to protect the IC. The Thermal
Shutdown circuitry turns off the NMOS power device when the die
temperature reaches excessive levels. The
UVP comparator protects the NMOS power device during supply power
startup and shutdown to prevent
operation at voltages less than the minimum input voltage. The OVP
comparator is used to prevent the output
voltage from rising at no loads allowing full PWM operation over
all load conditions. The LM2700 also features a
shutdown mode decreasing the supply current to 5μA.
Switching Voltage Regulators | |
SMD/SMT | |
TSSOP-14 | |
Boost | |
1.26 V to 17.5 V | |
3.6 A | |
1 Output | |
2.2 V | |
12 V | |
600 kHz to 1.25 MHz | |
- 40 C | |
+ 125 C | |
LM2700 | |
Reel | |
Cut Tape | |
Development Kit: | LM2700MT-ADJEV |
Input Voltage: | 2.2 V to 12 V |
Product Type: | Switching Voltage Regulators |
Shutdown: | Shutdown |
2500 | |
Subcategory: | PMIC - Power Management ICs |
Supply Voltage - Min: | 2.2 V |
Type: | Step Up |
Unit Weight: | 0.004949 oz |