Add to Cart
DOUBLE FACER
Structural features:
★ Heating plate surface by grinding treatment, hot plate width600mm, a total of 18 pieces heating plate, Cooling stereotypes Department 5 m.
Preheat board is made of contacts board, in accordance with the national standard of pressure container, enclosed the pressure container certificate and inspection certificate.
★ Hot plate using the touch plate design structure. Plate movements using a pneumatic spring-type structure.
★ On both sides of the upper conveyor belt deviation adjustment adopts automatic adjustment, 2 sets of the upper conveyor belt tensioning system.
★ The thermal pipe heating plate is divided into four sections to control the temperature, it has a temperature display.
★ upper cotton belt with double cylinder S cotton belt tensioning device.
★ lower cotton belt with s-shaped correction manually tensioning mechanism, structure simple and practical, under with manual fine-tuning.
★ Drive roller coated with attached wear-resistant rubber, showed a herringbone structure, With a high, ensure smooth cardboard output.
★ electric components used internationally renowned brands, device stable and reliable operation.
★ The main drive motor is variable frequency motor speed, low-speed torque, wide speed range, reliable, and easy maintenance.
★ hot plate internal for partition isolation structures-shaped flow of steam, Steam, water separation function significantly improves the utilization of steam.
★ The main backbone of high-strength GB profiles, solid structure, beautiful appearance, suitable for high-speed working.
Technical parameters:
Max. effective width | 1800mm |
Machine max. speed | 200m/min |
temperature requirement | 160—180℃ |
steam pressure | 0.8-1.3Mpa |
air source pressure | 0.6—0.9Mpa |
Heating plate quantity | 18 pieces |
operation direction: left or right(according to the customer’s factory) |
up drive rubber roller diameter | ¢700mm | Wear rubber Outsourcing |
bottom drive rubber roller diameter | ¢400mm | |
Former follower with roller diameter | ¢270mm | Note: All the roller surfaces after grinding are hard chrome plated |
After setting belt driven roller | ¢186mm | |
Pressure belt roller diameter | ¢70mm | |
Shaping roller diameter | ¢86mm | |
The belt tension roller diameter | ¢130mm | |
The roll diameter with detuning | ¢124mm | |
Under the belt tension roller diameter | ¢130mm | |
Entrusted with the roll diameter under the belt | ¢130mm |
Main drive motor power | 30KW 380V 50Hz | Continuous(S1) working standard |
Hydraulic station motor power | 2.2KW 380V 50Hz | Continuous (S1) working standard |