IP67 24VDC Floating Lidar System With Temperature Humidity Sensor

Temperature, humidity and pressure sensor installation Lidar System

1,Product introduction

In order to facilitate data transmission when the equipment is running in the field, the Molas B300/B300M wind-measuring lidar is equipped with a network communication module. This module requires customers to prepare a 4G data card with a flow of more than 10G for a month before installation. Please note that it must be a standard card (Kcal), the installation process of the communication module is as follows:

1) Open the SIM card installation cover with a flat-blade screwdriver;
Figure 10 Open the installation cover
2) As shown in the figure, insert the prepared SIM card into the card slot, so that the chip surface of the card is in contact with the bumps of the card slot, and be careful not to pull the card slot forcibly;
3) After confirming that the installation is correct, close the cover and tighten it with a screwdriver;
The WIFI user name is molas-B300, the initial password is "movelaser.com", and the lidar can be directly connected. Once installed, the installer can use your phone or laptop to connect to WIFI to check the network speed. This feature may not be available in some areas due to poor network signal in some areas.

2,Product parameters

3,Application scenarios

① Early detection of wind resources

② Offshore construction and operation and maintenance wind power monitoring

③ Prediction of wind power in offshore wind farms

MOVELASER