Driver fatigue monitor with signal output 45km/h start-up speed

Description

Product Information

RS232 communications
RS232 serial port offers data transmission. DMI can realize data interaction of vehicle running status, data transmission of alarm information and compressed images by connecting with matched vehicle networking terminal or other control equipment
Output interface
LS-803 has two-channel switch signal output to control auxiliary equipments, such as vibration cushions which start to work when the fatigue driving warning is issued. This can produce a strong vibration to remind the driver to pay attention to safety.
Over-speed Alerts
When driving speed is over 150km/h, DMI will alarm to remind.

Attention:

Non-authorized person, please do not open or repair the device.

Please do not operate the system when driving to avoid dangerous

Please handle carefully, do not drop or impact with hard objectives

Do not use chemicals or cleaning agents to clean the machine, it will damage the machine surfaces or rust the paint.

keep it away from water or moist place, device will be rusted or shortcut in those area.

Do not rip, bend or squeezed the wiring by heavy object, or it will be hot to fire.

Power input and output

1. Input: 9-36V, LS803 is suitable for both 12V and 24V vehicle, and have good high voltage protection.
2. very lower power consumption, average current less then 100mA in 12V car, and 60mA in 24V car, similar with leakage from the battery, almost does not consume battery power.
3. I/O output, high resistance status under normal status, low voltage output when triggered.
4. Working Temprature: 0-80℃
5. Working Humility: 10%-90%
6. Weigh:108g
7. Demension: 4.5*10.2cm

Leisure Auto Security Equipments Ltd, established in 2009, is a factory dedicate in car safety products, especially driver fatigue alarm system. the new products driver fatigue alarm is a fruit of our 8 years' research and development, it is different from any other kind of system on the market, it is the best way to monitor the driver's status.

It adopted the most advanced non-contact infrared camera to capture human eyelid and retina status,( in general, before entering drowsy driving status, human retina was less and less sensitive to the light outside), analyzes the driver’s fatigue status according to PERCLOS method, and give out voice alarm before the driver falling asleep.

It can also detect the driver’s distraction and give out voice reminders to prevent accidents, such as talking with back passengers, adjusting audio, or operating navigator, pick up thing from the ground and so on.