IEC 60884 13A Plugs Insulation Sleeve Wear Resistance Tester 4N Force
Brand Name:Sinuo
Certification:Calibration Certificate(cost additional )
Model Number:SN2128
Minimum Order Quantity:1 Set
Delivery Time:30 days
Payment Terms:L/C, T/T
Contact Now
Add to Cart
Verified Supplier
Location:
Guangzhou Guangdong China
Address:
Room 101, 1st Floor, No. 6, Third Street, Pingshan Industrial Zone 511495, Shibi Street, Panyu District, Guangzhou, China
Supplier`s last login times:
within 36 hours
Product Details
Company Profile
Product Details
IEC 60884 13A Plugs Insulation Sleeve Wear Resistance Tester 4N Force
Standards
IEC 60884-1:2006 "Plugs and sockets -outlets for household and
similar purposes- Part1:General requirements" clause 24.7 and
figure 28.
BS 1363-1-2012 "13A Plugs, Socket-outlets, Adaptors and Connection
Units Part1:Specification for Rewirable and non-Rewirable 13A plugs
figure 9.
Performance
The scraping frequency of this test device is 30 times per minute, and the return and return are recorded as one time respectively. The number of tests can reach 0-999999 times, the number of tests can be adjusted and set. The working stroke is 9mm, and the scraped insulation sleeve is 7mm. The pressure load is 4N, the diameter of the scraper wire is 1mm, and the effective length is 6mm
Structure
It consists of a horizontal beam and a fixture seat with linear movement. The end of the beam is equipped with a U-shaped head bent by a short steel wire with a diameter of 1mm (the two points of the U-shaped are fixed vertically on the beam). The u-shaped bottom edge of the steel wire is a 6mm straight working part. The U type steel wire 6mm straight bottom edge is pressed on the insulation sleeve of the bolt, and the motor drives the fixture seat with the bolt to do reciprocating movement, so that the friction between the steel wire and the insulation sample of the bolt is tested.
Sample range, use, principle, structure and use environment
| Samples and Restrictions | Insulation sheath for plug pin |
| Test purposes | It is suitable for testing the wear resistance of insulation sleeve of plug pin |
| The test principle of | Using motor drive eccentric mechanism to achieve the reciprocating scraping of the latch jacket |
| Equipment structure and characteristics | It consists of a horizontal beam and a fixture seat with linear movement. The end of the beam is equipped with a U-shaped head bent by a short steel wire with a diameter of 1mm (the two points of the U-shaped are fixed vertically on the beam). The u-shaped bottom edge of the steel wire is a 6mm straight working part. The U type steel wire 6mm straight bottom edge is pressed on the insulation sleeve of the bolt, and the motor drives the fixture seat with the bolt to do reciprocating movement, so that the friction between the steel wire and the insulation sample of the bolt is tested. Equipment dimensions: about 600×600×500 (mm) W×D×H, equipment weight: 70kg |
| Using the environment | Power supply: AC220V±10%/50-60Hz, working temperature 0-40℃ humidity 30%-90%; |
IEC 60884 13A Plugs Insulation Sleeve Wear Resistance Tester 4N Force
Inquiry Cart
0