Silent Operation Spa Water Pump Good Sealing Performance With Copper Wire

Pool Pump 1 Hp Swimming Pool Copper Pump Swimming Pool Pump 4hp

Features:

- Approved by ETL and CETL

- Pump, flange,impeller use high quality plastic.

- With electric current overloaded protector,Low noise.

- Good sealing performance.

- Good appearance,easy to use and maintain

- Silent operation

- Can resist chemical in swimming pool

- Pool motor with 48 frame

- Overload protection

- Huge pro-filter for less cleaning maintenance

- Arrange drain device of water pump

- Suitable for all types and sizes pools, in-ground spas

1) Magnificent flow rate and lift, the core energy of water circulating, 2~3m suction lift
2) Engineering plastic body, the pump can be effectively protected under bad weather,
long service life;
3) Seiko manufacturing, low noise during the pump working time;
4) Free-tool filter cover design, easy to maintenance;
5) IP55 protection level, with None-leaky design;
6) German technology IBC bearing, 100% copper wire motor, 24 hours running.
7) Anti-rust cast-aluminum motor cover, fast heat dissipation; PPO plastic steel material
impeller, resist high temperature and corrosion
8) Silicone sealing ring cover all watering section, enhance pump sealing system
9) CE certificated, reliable and safety

Description

• This Electric Swimming Pool Pump takes care of cleaning, filtration and chlorine/salt distribution.
• It features a revolutionised removable strainer basket with a built-in thermal overload protection as the water circulates and passes through the filter, it leaves your pool squeaky clean, free from leaves, hair strands, debris and other impurities.
• This is constructed with longevity in mind and employs extensive use of corrosion-proof materials resistant to the elements along with all chemicals commonly associated with pool maintenance.
• Voltage: 240 / 50Hz Power: 1200W/1.6HP. Class beating continuous 23,400L/HR flow
• Removable & cleanable high-temperature resistant filter basket.

Ask Technical informations to local agent or wholesaler. that can prove the are
qualified supplier, you can also order spare parts from them, Give the following
information when ordering repair parts:
1. Unit nameplate data or serial label number
2. Description of part
SERVICE & REPAIR PARTS
MOTOR DOES NOT START
FAULT ANALYSIS
1. Disconnect switch or circuit breaker off position
2. Fuses fusing or thermal protector open
3. Locked motor shaft
4. Motor winding burned out
5. Defective staring switch inside single phase motor
6. Disconnected or defective wiring
7. Low voltage
LOW PUMP CAPACITY
1. Inlet or discharge valve partly closed
2. Inlet or discharge valve partly plugged
3. Inlet or outlet too small
4. Hairs or foreign lugged strainer
5. Dirty filter
6. Impeller clogged
PUMP DOES NOT REACH FULL SPEED
Low voltage
Pump connected for wrong voltage
PUMP DELIVERS NO WATER
1. Pump is not primed
2. Suction or discharge valve closed
3. Leakage or air into suction system
4. Impeller clogged