PLC Control Metal Cutting Band Saw Hydraulic Saw Belt Tighten Style GZ4280

Plc Control Automatic Feeding Metal Cutting Band Saw Machine

Horizontal metal band sawing machine main components are: base;
Bed, column;
Saw beam and drive mechanism;
Guide device;
Workpiece clamping;
Tensioning device;
Feeding;
Hydraulic transmission system;
Electrical control system;
Lubrication and cooling system.
The hydraulic transmission system consists of pumps, valves, oil cylinders, oil tanks, pipelines and other auxiliary components of the hydraulic circuit, in the electrical control to complete the saw beam lifting, workpiece clamping.
Through the speed control valve can implement the stepless speed control of the feed speed, to meet the needs of sawing workpiece of different materials.
The electrical control system consists of an electrical box, a control box, a junction box, a travel switch, an electromagnet, etc., which is used to control the rotation of the saw blade, the lifting of the saw beam, the clamping of the workpiece, etc., so that the normal cutting cycle can be realized according to certain working procedures.
The lubrication system must be lubricated according to the lubrication parts of the machine (wire brush shaft, worm gear box, active bearing seat, worm bearing, up and down shaft of lifting oil cylinder, screw clamping on sliding surface of movable vise) before starting.
The worm gear and worm in the worm gear box are lubricated by no. 30 oil bath and injected by the oil plug hole in the upper part of the worm gear box. The box fairy surface is equipped with oil label.
Oil should be changed after a month of trial, and oil should be changed every 3-6 months after that. Oil drain plug is set at the bottom of the worm gear box.

The main components of double column horizontal metal band sawing machine are: base;
Bed, column;
Saw beam and drive structure;
Guiding equipment;
Workpiece clamping;
Tensioning equipment;
Feeding;
Hydraulic transmission system;
Electrical control system;
Smooth and cooling system.

Hydraulic transmission system by pump, valve, oil cylinder, fuel tank, pipeline and other auxiliary components of the hydraulic circuit, in the electrical control to complete the saw beam lifting, workpiece clamping.
Through the speed control valve can implement the stepless speed control of the feed speed, to reach the sawing requirements of the workpiece of different materials.

Electrical control system by the electrical box, control box, junction box, travel switch, electromagnet control circuit, used to control the rotation of the saw blade, saw beam lifting, workpiece clamping, etc., so that it according to a certain operating procedures to achieve the normal cutting cycle.

The smooth system must be lubricated according to the requirements of the smooth parts of the machine (steel brush shaft, worm gear box, active bearing seat, worm bearing, up and down shaft of the lifting oil cylinder, screw clamping on the sliding surface of the movable vise) before starting.
The worm gear and worm in the worm gear box are smoothed by no. 30 oil bath and injected by the oil plug hole on the top of the worm gear box. The box is equipped with oil label.
Oil should be changed after a month of trial, and oil should be changed every 3-6 months from now on. There is an oil drain plug at the bottom of the worm gear box.

Hei Yan Group Covers the following R&D abilities :

1. PLC induction pipe bending machine,
2. Cold forming tee machine
3. Automatic Hot forming elbow machine
4. hydraulic pipe expanding machine
5. Bevel machine
6. Hydraulic press machine.
7. Cold elbow forming machine
8. Bandsaw machine
9. Medium Frequency power source
10. Shot Blast Machine
11. Pipe fittings dies&mandrels
12. Steel pipe fittings