Heavy Duty Conveyor Belt , Side Belt Conveyor Low Elongation Avoid Torn Space Saving

Heavy Duty Conveyor Belt , Side Belt Conveyor Low Elongation Avoid Torn Space Saving

General

This Sidewall belt conveyor with corrugated shield, in particular applied in conveying material in big inclination, for it with corrugated shield and horizontal clapboard belt. And it can widely used in coal, metallurgy, chemical industry, light industry, petroleum, port, mechanical etc to convey all kinds of bulk materials and the piece.
Density of handled bulk materials 500~2500kg/m3, max inclination is 90°, max lump size is 550mm, lump of handled should depends on belt width, belt speed, clapboard height and inclination.
Ambient temperature generally -25~+40℃, material temperature to be handled should be under 50℃. It should take other measures for special requirement such as heat resistant, proof cold, resistant retard, resistant acid and alkali, resistant abrasion, proof explosion, proof water etc.

Advantages

• Widely used, can transfer all kinds of bulk material in different angles and directions.
• No transfer points- the belt are capable of turning at any angle right from feed hopper to discharge point
• No spillage at the steep angle when transfer bulk material.

• Maximum utilization of space – able to convey material at angles up to 90 degree, able to instead of bucket elevator.

• 
  Low power requirement, low cost, long service life and quiet smooth running.

Application

Sidewall belt conveyor can be used in coal, chemical industry, building materials, metallurgy, electric power, light industry, food, port, shipping and other industries, in the working environment that the humidity is -15 degree to +40 degree, transport a variety of bulk materials which density is 0.5-2.5t/m3.

Technical parameters for reference

Remarks: the below capacity is based on coal and speed 1m/s to caculated for reference.

Operation regulation and maintenance

• Belt conveyor should be operated in according to design requirement.

• Belt conveyors are not allowed to overload run.

• All safe alarming should be in good condition.

• Check wear condition of the belt, the damaged should be repaired.

• Operators should circuit to inspect to close observe belt conveyor running. Especially,temperature rise and noise of main motor and the brake working whether they are normal; contact state of the brake and oil level, noise of gear unit and run off of belt should be noticed;temperature rise and noise of all bearings and state of all transition loads point should be noticed;
  notice to see whether the hopper are blocked, working state of pulley, idler, belt cleaner, take-ups and control equipment.

• Operators should make good record if any abnormal. The belt conveyor should be stoppe on emergency.

• Periodic overall: Minor overall should be once every monthes besides ordinary maintenance Overhaul should be once half past year or once every year.