Customization Rubber Track Undercarriage For Agriculture Super Trafficability

Customized Design Rubber Track Undercarriage For Agriculture Application

Product Description

The track shoe is fixed on the rail joint with high-strength bolts, and the chain rail joint and the rail are slightly pressed together with the chain rail sleeve in the way of interference fit. This vehicle uses a track with a pitch of 135mm. The track of the track is slightly sealed with a special rubber ring to prevent sand, water and other abrasive particles and corrosive media from entering the mating surface of the relative rotation.

Product Technical Parameter

Product Advantages

1. The grounding ratio is low to protect the soil

The bottom layer of plough shall be avoided in dry land by dragging with shoes to keep moisture and prevent drought; The paddy field shall prevent damaging the hard bottom and ensure the normal cultivation of the paddy field; The specific pressure of wheel tractor grounding is three times that of shoe tractor. The test shows that the emergence rate of cultivated land after being compacted by wheel tractor is only 30% - 40%, while the emergence rate after being compacted by shoe tractor can still reach 80% - 90%; The wheel rut of the paddy field affects the transplanting and harvesting, and even causes the mud foot to deepen and cannot be cultivated.

2. Large tractive force, obvious advantages of deep turning and load bearing operation

The tractive force of the wheel tractor with the same weight is 1.4-1.8 times that of the wheel tractor. In terms of tractive efficiency, the maximum tractive efficiency of the wheel tractor is 55-65%, and that of the crawler tractor is 70-80%. That is to say, the effective power of the wheel tractor engine is 15% more than that of the wheel tractor with the same horsepower.

3. Super trafficability and climbing ability

The crawler tractor has good slope stability against overturning and sliding due to its low center of gravity and large coefficient of adhesion, and also has the characteristics of small turning radius, maneuverability, strong climbing ability and cross-country performance. It has better adaptability than the wheel tractor for farmland and terrace operations in mountainous and hilly areas, especially when equipped with rubber tracks, it belongs to all-terrain operation machinery.

Its biggest disadvantage is that the driving speed is slow, and it is very inconvenient to transfer. The all-steel track will seriously damage the road surface, and some areas restrict the use of tracked tractors.

Product Application

Crawler chassis assembly is mainly used for special occasions, such as military parade, tanks, armored vehicles, etc. What are its advantages: rubber track has the advantages of protecting the ground, rubber track walking system, low noise, low vibration, comfortable riding, etc. It is suitable for situations with high speed and many transfers, and achieves the all-road performance. Reliable electrical instruments and complete machine status monitoring system provide reliable assurance for the driver to operate correctly

Due to the different use methods and soil conditions, the working life of rubber track also varies greatly. Generally speaking, its average life is about 2000 hours. However, when working in rock or easily worn environment, the service life will be halved; On the contrary, the working life will be doubled in a better environment. When the user checks the track and chassis, don't forget to drive again to check the oil level and cleanliness. This part is easy to be ignored, and there is usually less oil left.

Product Working Attentions

(1) It is forbidden to turn sharply on the concrete ground or hard road, otherwise the track core will be worn and the belt body will be twisted.

(2) When crossing the ridge, it is necessary to move forward at a low speed at right angles to the ridge. When crossing the ridge with a height of more than 10 cm, it is necessary to use a springboard, otherwise the track may fall off or be damaged.

(3) It is forbidden to walk and turn sharply for a long time on the gravel road, otherwise the track will be accelerated, worn and cracked.

(4) Do not work on rotten fields, otherwise the track will slip and make the traveling mechanism accumulate mud and tangle grass, affecting the normal operation.

(5) If stones or foreign matters enter between the track and the underframe, stop the operation immediately and remove the stones or foreign matters.

(6) After working on the beach or in the field sprinkled with chemicals, the track shall be washed in time.

Jinzhou City Shitan Machinery Equipment CO. LTD. is a professional production and

processing company for core drilling rigs, crawler drilling rigs, various track chassis, various

types of mud pumps, various track transport vehicles, etc. It is one of the outstanding

manufacturers of similar products in North China. Strong technical force. The modern production

equipment and complete testing means are specialized in the development, manufacture and

marketing of drilling rigs.

To ensure the quality and stability of the machine, we use the most advanced production and testing

equipment, Made from high quality materials, with fashion and compact design, that keeps our drilling

rigs more efficiency and with low failure rate, more economic and durable, and with a high comprehensive

cost performance. Our water drilling rigs have received the real market validation as the majority of our

customer’s positive feedback.

The company's main products are rigs: XY-1, XY-1A, XY-1B, GK-180, GK-200, DPP-100 and other series

of drilling rigs: gearbox assemblies and gyro assemblies for various rigs, Winch assembly, reducer assembly,

pump assembly. Drilling tools: sedimentary pipe joints, casing joints, casing couplings, drill pipe joints, casing

core pipes, lifters, automatic drop hammers, earth borrowers, standard penetrations, forks, lock joints, alloy drill

bits Hundreds of drilling tools, such as steel sand drill bits, core pipe joints, drill pipe pliers, and casing pliers.

Jinzhou City Shitan Machinery Equipment CO. LTD. has a complete and scientific quality management

system. The integrity, strength and product quality of Jinzhou Stone Exploration Machinery Co., Ltd. have been

recognized by the industry. Welcome friends from all walks of life come to visit, guide and negotiate business!