Lithium Charger 48V 72V 96V 312V Battery Charger 6.6KW Car Charger With CAN Protocal

Car battery charger​ lithium battery charger introduction

• Deligreen 3.3kw/6.6kw Fully enclosed frequency conversion pulse charger is specifically designed for electric vehicle power batteries according to the national standards for chargers.
• This product has the advantages of high efficiency, small size, high stability, long life, etc., and the full waterproof technology has the characteristics of safe operation, high reliability, complete protection and other characteristics under the protection level of IP66. The built-in thermal sensor of the charger can work reliably under the condition of -20 ℃- + 85 ℃; it has overheat protection function, it can work reliably under the condition of -20 ℃+ 85℃, and it can recover automatically.
• The battery charger is IP66 waterproof,guarantee it can work in any weather

Wide voltage option

Besides 220V,110V fixed input voltage,this S2 car charger is available with wide range of input voltage

Electrical parameters

Protection function

Shape and size

combination of 2 3.3KW battery charger

6.6KW Air cooling

Horizontal mounting size within S2-6.6KW

Connector type

Indicator status definition

7.1 No alarm

a. Charging operation status: The red light flashes at 1s intervals, and the green light is off.

b. Heating operation status: The green light flashes at 1s intervals, and the red light is off.

c. Waiting state: The green light is always on and the red light is off.

7.2 With alarm

a. Hardware failure or DC12V failure: red,green, , , , .

b. PFC, CC & CP slave CPU communication failure:

red,green,red, , , .

c. DC bus voltage failure: red,green,red,green, , .

d. Low or high AC voltage protection: red,green,red,green,red, .

e. Battery is not connected: red,green,red,green,red,green.

f. Segment charge timeout protection: red, , ,red, , .

g. Battery temperature protection: red, , ,red, , .

h. CPU temperature or transformer temperature protection:

green,red,green, , , .

i. Output short-circuit protection: green,red,green,red, , .

j. Transformer primary overcurrent protection:

green,red,green,red,green, .

Product appearance

(1) The outer surface should be flat, without obvious defects such as scratches and deformation. The surface coating should be uniform.

(2) The nameplates and signs are firmly installed and the handwriting is clear.

(3) The parts and components shall be fastened and reliable, and shall be free from defects and damages such as rust, burr and cracks.

(4) Each product shall be marked with a product logo, including part number, product trademark, product model, production number, production company name, warning instructions, etc., at obvious locations.

Packaging, transportation and storage

Packaging: Product name, model, specification, name of manufacturer are printed on the label . The box contains the product manual.

Transportation: It is suitable for transportation by car, boat and airplane. It should be protected from sun, moisture and civilized transportation during transportation.

Storage: When the product is not in use, it should be stored in a packing box. It should be kept in a clean, dry and well-ventilated environment at 5 ℃ ～ 40 ℃. Avoid exposure to sunlight, fire and water. The product has a shelf life of 2 years (from the manufacturer,from the date of storage), if the storage time is too long (more than 2 year), it should be tested by professional before use.

BMS: CAN BUS COMMUNICATION SPECIFICATION

1. Communication Specification

The principle for data link layer.

Communication speed for bus line: 250Kbps.

The provision for data link layer: Refer to the related regulation of CAN2.0B and J1939.

Use and redefine 29 identifiers of CAN extended frame. The distribution of 29 identifiers are listed below:

Priority has 3 bits so there can be 8 priorities. R is generally 0. DP is fixed at 0. 8-bit PF is the code for the message. 8-bit PS refers to destination address. 8-bit SA refers to the source address.

›There is a name and an address for every node which accesses to the network. The name is used for nodes identification and address arbitration. The address is used for data communication to node.

›Every node has at least one function. Multiple nodes might have the same function or one node might have multiple functions.

What is car battery charger?​

• An electric vehicle/E-car charger is a device designed to charge the vehicle battery of an electric vehicle. A power conversion device with specific functions is used to charge the battery. Electric vehicle chargers can be divided into DC chargers and AC chargers.

How many amps do I need to charge a 12 volt battery?

• Most battery manufacturers recommend sizing the charger at about 25% of the battery capacity (ah = amp hour capacity). Thus, a 100 ah 12 volt battery would take about a 25 amp 12 volt charger (or less).

​Where is the best car battery charger to buy?

• Deligreen supplies the high quality car battery charger and it's highly accepted by customers,pls send your inquiry at the end of this page,we will contact you soon.

About the Transportation&Delivery

1. Shippment to USA:By sea+Express(DDP,Tax free)
ETD:5-8 days
ETA:25-35 days after sailing(This is the delivery time for most orders. Please wait patiently or contact us online)
The tracking will be updated after pick up by local express.Usually it will take around 15-25 days after sailing.

2. Shipment to EU:By railway+Express(DDP,Tax free).Except Switzerland,Romania
ETD:5-8 days
ETA:30-45 working days after shipping(This is the delivery time for most orders. Please wait patiently or contact us online)
The tracking will be updated after pick up by local express.Usually it will take around 25-40 working days after shipping.

3. We can't deliver the following address directly:
USA: Military address and PO box address are not acceptable;

Puerto Rico, Virgin Islands, Guam, Alaska Note: Hawaii does not include customs duties and requires additional freight, Please contact us online.
Portugal: Azores and Madeira
Spain:Canary Islands, hueda and melilia
Russia: Kamchatka Peninsula
Other:Some remote areas not listed,Please provide shipping address and zip code to to us to check.

About US

Changsha Deligreen Power Co.LTD,founded in 2010,is a "Green Energy Solution Service Provider".

Newest technology,new idea,heard-working and honest people.

Focus on lithium rechargeable battery,BMS,Balancer,charger and relative products.

Main application:electric bicycle,scooter,motorhome,AGV,solar/wind system,Energy storage system,truck and so on.s:

We promise"real"lithium capacity

We promise“100%“ refund for any quality problem

We promise”100%“ replacement for any shipping damage

We promise lifetime fast technical supportCustomers‘ satisfaction is our endless pursuing.

FAQ

• Is CAN protocal availabe?
• Yes,we can supply CAN for your battery communication,
• Is there LED light?
• Yes,there're RED/YELLOW/GREEN led lights for charging.
• Can Li-ion battery high-power chargers be charged in constant voltage mode?
• Lithium battery is constant current charging
• What is Single-phase electricity?
• Single-phase electricity refers to the form of electric energy transmission consisting of a phase wire (live wire) and a neutral wire

Changsha Deligreen Power Co., Ltd. was established in 2010 .

Deligreen is a one stop power system provider, engaged in research and development and sales of lithium battery and its accessories.

We target at offering high quality products with fair price for residential and commercial energy storage, solar system and Electric vehicles.

The main products are the distribution of large cell of domestic famous brand,battery pack ,BMS, Active balancer, charger, home energy storage and electric vehicle charging cable. Among them, the active balancing module is our unique advantage product. There are few technologies in China that can truly achieve active balancing and protect the battery. After three years, we have built our own brand product, Deligreencs BMS, which sells well in more than 60 countries around the world. The company structure is divided into three parts: factory, warehouse and office. The warehouse has more than 200 commonly sold standard products of BMS and electric vehicle charging equipment, which can provide fast delivery for factories,retailers and distributors. We have warehouse in US,PL, RU ,which help customers receive the goods in 5~7days.

At present, there are more than 15 office staff, including one designer, one technical consultant and one after-sales support. They have received professional training and have good business and communication skills. At the same time, our company provides customers with marketing support and planning scheme. The business philosophy of the enterprise is: let the staff get material and spiritual benefits. Treat every customer as a lifetime customer. Hope to get a long and stable development.