

Add to Cart
Wireline Fishing Tool Lead Impression Block
I. Overview:
The lead printing is used to print the shape and size of the fish
in the well, so as to determine the tools and measures that should
be used in the next fishing operation.
II. Technical parameters:
Tools O.D. | Fishneck O.D. | Connection Type |
1.0"~1.5" | 1.187" | 15/16-10UN |
1.5"~2.0" | 1.375" | 15/16-10UN |
2.0"~2.5" | 1.375" | 15/16-10UN |
2.5"~3.0" | 1.75" | 1-1/16-10UN |
3.0"~4.0" | 2.313" | 1-1/16-10UN |
4.0"~5.0" | 2.313" | 1-1/16-10UN |
5.0"~6.0" | 3.125" | 1-9/16-10UN |
Special specifications can be provided according to customer
requirements
III. Structural features and use:
1. The lead stamp is a tool for filling lead in the pipe sleeve.
When the lead print hits a falling object with a higher hardness
downhole, it deforms, and the shape and size of the falling object
are recorded. After use, the traces can be cleaned up, stored
carefully, and can be recycled until the exposed lead body is used
up.
2. When going down the well, it is connected to the basic tool
string to go down the well.
3. Go down to the place of the falling object and hit it slightly
downwards once. (Note: Do not repeat the shock, so as not to
reprint the figure on the lead, which will make it impossible to
judge the shape and size of the fish.
IV, matters needing attention:
The lead print must be well protected during transportation and
storage, and no bumps are allowed.
Welcome to contact us at any time.