12V 100W PWM Control Electric Car Coolant Pump New Energy Brushless For EV Bus

JUNQI 12V 100W PWM Control Electric Car Coolant Pump New Energy Water PUmp Brushless Water Pump For EV Bus

♣ Features

♦ Single stage centrifugal pump

♦ Magnetic force transmission (shield pump structure)

♦ High efficiency brushless DC motor, low power consumption, high efficiency, long service life.

♦ With wide range operating temperature

♦ PWM signal speed controlling (optional PG signal feedback )

♦ With constant flow controlling

♦ Reverse polarity protection

♦ Dry running protection

♦ Over Voltage, over current protection

♦ Overload, over temperature protection

♦ Automobile grade electronic components

♣ Technical description (parts in contact with the liquid)

Pump head housing: PPS+GF

Impeller: PPS+GF

Shield cavity: PPS+GF

Shaft bearing: Carbon resin composite materials+ zirconia ceramic washer

Shaft: hollow stainless steel shaft

Rotor: nylon injection packed

Seal ring: EPDM

♣ Driving device (Including motor)

Driving electromagnet: magnet+nylon injection packed

Screws and nuts: SUS 304 stainless steel

Driving Motor : brushless motor

Motor wire frame: PPA+GF (white)

Pump housing: aluminum alloy

Bracket: SUS 304 stainless steel

Bracket hoop: US 304 stainless steel+ Damping rubber ring

Waterproof based on IP68 rating (en60529)

Connector:3 Pins or 4Pins (with PG signal feedback)

Nozzle diameter:22.2mm (inner diameter:20mm)

♣Basic information

♣ Mounting instruction:

♣ Temperature parameter

Medium liquid temperature: -40℃ to +120℃ (-40°F to + 248°F)

Working ambient temperature: -40℃ to +100℃ (-40°F to +212°F)

Storage temperature: -40℃ to +70℃ (-40°F to +158°F)

(up to 100 ℃, but it will shorten the service life)

♣ System pressure

-0.2 to 2.5 bar ( 100℃ (212°F).

The service life is more than 20,000 hours based on the rated voltage and 36℃(86°F) ambient temperature.

♣ Connector model and Pins

♣ Attentions

1. Working ambient temperature:-40℃--120℃, should try to avoid close to three-element catalytic, gas discharge pipe system and engine during the installation, ensure the working environment temperature.

2. The installation position of the water pump should as much as possible close to the low water level, to extend the service life of the pump.

3. In order to reduce water resistance, should as much as possible to reduce the number elbow in piping in the installation, ensure no any elbow within 20 cm from the pump.

4. Please use the pump far from the dusty environment, the dust is harmful to reduce the service life

5. Pay attention to the purity of the water, avoid to jam and impeller-blocked to reduce the service life of pump.

♣ Curve chart

♣PWM Control Description:

♣Overall dimensions

♣Applications:

Apply to HEV(Hybrid Electrical Vehicle),EV(Electric Vehicles), trains, ships and other heating circulation and cooling circulation system.