Polyurethane Imide , Impact Resistant And Anti Peeling Air Filter Adhesive
Brand Name:Chang Feng
Certification:ISO9001
Model Number:9009-54-2
Minimum Order Quantity:5 / Tons
Delivery Time:8-10 work days
Payment Terms:L/C, T/T
Contact Now
Add to Cart
Site Member
Location:
Hengshui Hebei China
Address:
Changfeng Filter Element Material Factory, No. 5, Filter Material City, Anping County, Hengshui City, Hebei Province, China
Supplier`s last login times:
within 23 hours
Product Details
Company Profile
Product Details
Polyurethane Imide, Impact-Resistant And Anti-Peeling Air Filter Adhesive
1. Product introduction
The position of the end cover is to integrate the filter paper and the framework at both ends of the filter element. The function of the filter element glue is to bond the end cover and the filter paper framework
2. Parameter table
Two-component polyurethane adhesive for machine component proportion ratio is 100:25 | ||
| Material-A | Material-B | |
| Weight | Small barrel :25KG | 6.25KG |
| Big barrel :50KG | 12.5KG | |
| Physical nature | orange-red viscous liquid (color based on your request to configure) | brown-yellow liquid |
| viscosity | 800-1000MPa.S(25°C) | 25-50MPa.S(25°C) |
| density | 1.02g/ml | 1.02g/ml |
| package | Plastic bucket or Tin bucket | Plastic bucket ,Tin bucket, Plastic pots |
| storage | 1. Material-A and material-B can store up 3-6 months. | |
| 2. To appropriate indoor storage above 15°C | ||
3. Method of operation
1. The surface of the end cover shall be cleaned to remove oil and
dust, and dried thoroughly. There shall be no oil, water and other
foreign matters on the surface, otherwise it will affect the
bonding strength.
2. Inject an appropriate amount of adhesive into the end cap and
place it for a moment to make the adhesive surface smooth and
coated on all parts of the end cap.
3. Insert the filter element paper (or add a central pipe) into the
end cover, check the surfaces of the two adhesive parts to ensure
that they are in full contact, and then put a little pressure on
the top to stand.
4. After curing for about 1 hour, turn over and glue with the other
end cover. Package after 24 hours of complete drying, and use after
5 days.
4. Do’s and don’ts
1. The products are generally stored in a dry room, and pay attention to water, moisture and sun. Must cover the plug and cover, to avoid absorbing rubber moisture in the air, affect the results
2. Mould must be painted in front of the mould release agent,to be poured glue dry before.
3. A.B glue in ordinary temperature of 25 °C properly used, if the temperature is too high or too low will affect the use effect. You must use artificial methods of cooling or heating.
5. Matters Needing Attention
During bonding, the cover shall be cleaned without dirt. It is best to apply some glue on the cover first, then brush glue on the adhesive strip, and wait a few minutes before bonding.
Polyurethane Imide , Impact Resistant And Anti Peeling Air Filter Adhesive
Inquiry Cart
0