MMF SR 10G SFP+ Fiber Transceiver Module 850nm 300m LC Duplex Connector

MMF SR 10G SFP+ Fiber Transceiver Module 850nm 300m LC Duplex Connector

10G-SR SFP+ 850nm 300m DOM LC MMF Juniper Transceiver Module

Optical Characteristics (TOP(C) =0 to 70 ℃,TOP(I) =-40 to 85 ℃,VCC = 3.13 to 3.47 V)

Notes:

1. Measured at 10.3125b/s with PRBS 2^{31 – 1} NRZ test pattern.

2. 20%~80%

3. Under the ER worst case=4.5@ 10.3125 Gb/s with PRBS 2^{31 - 1} NRZ test pattern for BER < 1x10^-12

Absolute Maximum Ratings

Note: Stress in excess of the maximum absolute ratings can cause permanent damage to the transceiver.

General Operating Characteristics

Electrical Characteristics (TOP(C) =0 to 70 ℃,TOP(I) =-40 to 85 ℃,VCC = 3.13 to 3.47 V)

Note:

1. Connected directly to TX data input pins. AC coupling from pins into laser driver IC.

2. Into 100Ω differential termination.

3. 20 – 80%. Measured with Module Compliance Test Board and OMA test pattern. Use of four 1’s and four 0’s sequence in the PRBS 9 is an acceptable alternative.

4. LOS is an open collector output. Should be pulled up with 4.7kΩ – 10kΩ on the host board. Normal operation is logic 0; loss of signal is logic 1.

Descriptions

Olinkcom's OLSP851XL-CDS3 Enhanced Small Form Factor Pluggable SFP+ transceivers are designed for use in 10-Gigabit Ethernet over MultiMode fiber. They are compliant with SFF-8431,SFF-8432 and IEEE 802.3ae 10GBASE-SR/SW. The transceiver designs are optimized for high perform-ance and cost effective to supply customers the best solutions for telecommunication and datacom.

Applications

● 10G Fiber Channel

● Other optical links

Shenzhen Olinkcom Technology Co.,Ltd established in the year of 2011, is a professional manufacturer of optical transceivers. We are dedicated to designing, developing, production and distributing optical transceivers to fulfill customer’s requirements for optical communication. Olink is able to offer a vast range of optical modules from 155Mbps ~ 100Gbps, including CFP2, QSFP+, XFP, SFP+, SFP, PON and CWDM, DWDM solutions, to support various protocols and meet with different requirements on Fiber Channel, Ethernet, SONET/SDH, FTTx, Data Center etc. And all product quality is backed by our strong R&D ability, rigorous quality control procedure and rich production experience. Our modules are exported to China domestic market, Asia, Southeast Asia, Europe and the American market, etc.

With the concept of “Quality First, Service Oriented, Realistic and Innovative, Continuous Improvement”, Olink keeps developing and optimizing product design solutions, to provide our valued customers with the most cost efficient product and service, as well as some customized products.