High Starting Torque High Frequency VFD PMSM Inverter for Synchronous and Asynchronous Motors

1phase/3phase 220V:200V～240V

3 phase 380V-480V:380V～480V

General purpose application:60S for 150% of the rated current

Light load application:60S for 120% of the rated current

V/f control

Sensorless flux vector control without PG card(SVC)

Sensor speed flux vector control with PG card (VC)

1:100 (V/f)

1:200( SVC)

1:1000 (VC)

±0.5% (V/f)

±0.2% (SVC)

±0.02% (VC)

5Hz(V/f)

20Hz(SVC)

50Hz(VC)

0.00～2000.00Hz(V/f)

0.00～200.00Hz(SVC)

0.00～400.00Hz(VC)

Digital setting: 0.01 Hz

Analog setting: maximum frequency x 0.1%

150%/0.5Hz(V/f)

180%/0.25Hz(SVC)

200%/0Hz(VC)

SVC:within 5Hz10%,above 5Hz5%

VC:3.0%

V / f curve type: straight line, multipoint, power function, V / f separation;

Torque boost support: Automatic torque boost (factory setting), manual torque boost

Support linear and S curve acceleration and deceleration;

4 groups of acceleration and deceleration time, setting range 0.00s ~ 60000s

Overvoltage stall control: limit the power generation of the motor by adjusting the output frequency to avoid skipping the voltage fault;

Undervoltage stall control: control the power consumption of the motor by adjusting the output frequency to avoid yaw failure

VdcMax Control: Limit the amount of power generated by the motor by adjusting the output frequency to avoid over-voltage trip;

VdcMin control: Control the power consumption of the motor by adjusting the output frequency, to avoid jump undervoltage fault

Standard:

MODBUS communication

CAN OPEN AND PROFINET( IN DEVELOPMENT)

Standard:

5 digital input terminals, one of which supports high-speed pulse input up to 50kHz;

2 analog input terminals, support 0 ~ 10V voltage input or 0 ~ 20mA current input;

Option card:

4 digital input terminals

2 analog input terminals.support-10V-+10V voltage input

standard:

1 digital output terminal;

1 high-speed pulse output terminal (open collector type), support 0 ~ 50kHz square wave signal output;

1 relay output terminal(second relay is an option )

2 analog output terminals, support 0 ~ 20mA current output or 0 ~ 10V voltage output;

Option card: 4 digital output terminals