Fixed Type Double Pipe Connector Stamping for lean pipe system

Fixed Type Double pipe connector

Product introduction

The installation method of right angle vertical metal joint is somewhat similar to that of T-type straight joint. It only need one pair of M6 * 25 bolts to complete the installation process. The surface of right angle vertical joint can be provided with holes to further drive self-tapping screws to strengthen the fixation of the pipe and the joint. The thickness of 2.5mm also ensures the high bearing capacity of the joint. After the joint is grinded, the burr on the joint surface can be greatly reduced or even completely cleared, effectively reducing the risk of injury to workers in the workplace. And the surface treatment of the joint adopts electroplating, which can effectively prevent its rusting and prolong the service life of the joint.

Features

1. Two equipotential lines on both sides of the product, so the installation position of the tube can be known when using. Auxiliary user installation.

2.The thickness of the product is up to 2.5, 25% thicker than most products, with stronger performance and higher bearing capacity.

3. Holes are reserved on the surface of the product, and self-tapping screws can be inserted later to better fix the pipe.

4. Products can be customized with logos and marked with models according to different needs of customers.

Application

Right-angle vertical joints require two identical joints and a pair of m6 * 25 bolts to be assembled. Screw holes are reserved on the outside of the connector to facilitate the connection between the connector and other accessories. This joint is often used for the movement and fixation of the circuit board peripheral car frame. The groove on the joint surface can increase the friction between the joint and the pipe, making it more stable. Moreover, the connection between the connector and the lean pipe conforms to human mechanics. Parallel single -side swivel metal joint is often used in various material racks and turnover vehicles. This joint is required for the connection between the board and the lean pipe. It is the most commonly used joint in the lean pipe system.