

Add to Cart
1.Product introduction
With the development of the times,LED indoor flexible modules have
been unable to meet the current people's requirements for the
perfect combination of shape and practicality.However, the
emergence of outdoor soft modules has gotten rid of the pain points
oftraditional soft modules that are only installed in the indoor
environment without waterprooffunction. Outdoor soft module before
and after waterproofing process can meet the indoor /outdoor
environment conditions at the same time, but also has soft and
flexibe performancethe traditional indoor soft module can not match
the waterproof advantages and highbrightness display effect, Module
can be assembled: inner arc display surface, outer arcdisplay
surface, corner screen display surface, Can meet the different
outdoor modeling,widely used in: outdoor central square, exhibition
venues, high-end shopping malls, airporstations and other public
places and many other media release display places and a widerange
of applications. Let the outdoor display more than the plane
2.Product Features
Modular standard size design 320 X160mm, low current, low heat,
high contrast, high refresh
Bottom shell supporting 18 magnets, a single magnetic content of up
to 2500Gs, sothat the module and the box between the adhesive force
is stronger, the magnet anti-salt spray, anti-corrosion test for 48
hours, the magnet level up degree can be adjustedeffectively
improve the flatness of the screen and the use of the effect;
Support front install / maintain, front and back wate rproof
process to achieve lp65s classification of waterproof
Moduile lamp surface with a protective mask, protect the lamp
beads, anti-reflective, prevent solisd dust into
The back cover ofthe bottom shell adopts a honeycomb design
pattern, and the back cover ofthebottom shell can be removed for
convenient maintenance, which can better protect thecomponents on
the back ofthe module and prevent the module from being damaged.
Anti-falling safety rope combinedwith magnetic strengthening,
adding a layer ofsecurity, toprevent the module from falling due to
environmental wind or high-altitude installation operations;
3. Key Parameters
Part Number | FW-C3 | Part Number | FW-C3 |
Pixel Configuration | 1R1G1B | LED | SMD 1415 |
Pixel Density | 105625dot/㎡ | Module Size | 320*160*12mm |
Module Resolution | 104*52 | Scan | 13S |
IC | PWM | Refresh Rate | 3840Hz |
Repetition Frequency | 60Hz | Gray Scale | 12bit |
Assembled Diameter | 1019mm | Camber | ≥162° |
Signal Interface Mode | HUB75 | Shell Material | Silicone Soft Shell |
Module Weight | 610g/pcs | Flatness | ≤0.5mm |
IP Rate | IP65 | Installation/Maintenance Mode | Front |
Luminance | 5000cd | Color Temperature | 9000-9500k |
XY | X:0.2800 Y:0.3000 ±0.01 | Viewing Angle | H/V 140° V/V120° |
Contrast Ratio | ≥3000:1 | Module Supply Voltage DC | 5V |
Max. Module Current DC | 6A | Max. Module Power Consumption | 30W/pcs |
Working Input Voltage AC | 220V | Peak Power Consumption | 590W/㎡ |
Average Power Consumption | 168W/㎡ | Lifespan | 100,000h |
Operating Temperature | -20~50℃ | Operating Humidity | 20%~90%RH |