33km UAV Video Data Radio Anti-jamming Mesh Radio Support 32 Nodes
Share 100Mbps
Technical Specifications
Model number | HCL602-2 |
---|
Modulation | TDD OFDM |
---|
Frequency | 566~678MHz and 1420~1530MHz |
---|
Bandwidths | 1.4/3/5/10/20/40MHz |
---|
Throughput | Maximum 100Mbps |
---|
RF transmission Power | 2W*2 |
---|
Constellation | QPSK, 16QAM, 64QAM, self-adaption |
---|
Sensitivity | -102dBm (1Mbps at 20MHz) |
---|
IP data transmission (3 Ethernet port) | Support |
---|
Serial data transmission (1 channel RS232 or TTL) | Support |
---|
Transmission range | 1~7km (ground to ground), maximum 33km (UAV to ground) |
---|
Management | Through Web UI or Control UART |
---|
Encryption | AES128-bit encryption |
---|
Network mode | Mesh |
---|
Movement speed | Support maximum 300km/h |
---|
Power input | 12~18V |
---|
Power consumption | <2A at 12V |
---|
Dimensions | 118.4*61.4*29 mm |
---|
Weight | 235g |
---|
Characteristics
- TDD OFDM wireless video data transceiver support Mesh Networking
- Up to 100Mbps Iperf Throughput
- Control by web browser or control UART
- 3 Ethernet and 1 channel RS232/TTL for data link
- Maximum 33km long distance fhss video data links for UAV/ UAS
- Frequency hopping technology (FHSS) to ensure stable signal
communication.
Input/Output Connections
Connection | Description |
---|
Ethernet | 3 channel 4Pin PH1.25mm connector, bridged inside with same IP
address |
Data UART | RS232 data UART (RS232 as default, optional TTL before shipping
out), 3PIN PH1.25mm connector |
Control UART | TTL control UART, 3PIN PH1.25mm connector |
Power in | XT30PW-M connector |
ANT 1 | Tx/Rx Antenna port, SMA female |
ANT 2 | Tx/Rx Antenna port, SMA female |
This HCL602 2W IP Mesh Radio supports mesh network with maximum 32
nodes and shared maximum 100Mbps Iperf Throughput.
- Mesh network capacity: supports a maximum of 32 Nodes (2≤N≤32)
- Transport: unicast, multicast, and broadcast are supported
- Time synchronization: self-synchronization without external clock
- Power control: adaptive transmission power adjustment
- Topology: supports multi-hop routing with maximum 32 nodes and 31
hop routing
- Routing: automatic routing adjustment with fixed route
configuration option
- Data rate level: adaptive average distribution system rate
- >Transmission delay(Note: N is the number of nodes within two hops,
hop number: H)
- >Common scenario calculation formula, One-way delay indicator
formula (MS): 6*H + (5/2) * N/2 *H * 3, Two-way delay multiplied by
2;
- >Two-node optimization delay: unidirectional delay of one hop
between two nodes <= 10ms;
- >Four node chain optimization delay: three-hop single-hop
unidirectional delay of four nodes <= 10ms;
- >Typical system delay(from big data statistics):
- Six point-chain networking, three hops, unidirectional delay:
50ms;
- 8 points, all points one hop, one-way delay: 36ms;
- 8 points, serial 7 hops: unidirectional 170ms
9. Boot time delay:
- >Network establishment delay of logical main control node after
startup 20-80s. (Generally, the logical main control node is the
node which turned on firstly);
- >Cold startup: The network access delay of the logic access node is
less than 30 seconds, and the logical main control node signal is
received;
- >Hot startup: The latency of connecting the secondary node to the
network is less than 1s (common one-hop node networking scenario)
Frequently Asked Questions
Q1: Does this Mesh Radio support any other cameras except IP
camera?
A1: IP camera video can be connected with HCL602 directly via
Ethernet port. HDMI/SDI/AHD/AV camera video can be encoded with our
SE10/SE11 encoder and then work with HCL602 via Ethernet
connection.
Q2: How to select the frequency band?
A2: 1.Based on the transmission distance (lower frequency can
transfer farther), 2. Data rate (higher frequency has a higher
rate), 3. Regulations (such as the EU's restriction on 433 MHz)