Securement Of Pins Australian/NZ Plugs And Socket Outlets AS/NZS 3112:2017 Test
Brand Name:KingPo
Certification:Calibration certificate
Minimum Order Quantity:1
Delivery Time:30 working days
Payment Terms:T/T
Place of Origin:China
Contact Now
Add to Cart
Verified Supplier
Location:
Hong kong Hong kong China
Address:
RM C, 13/F, HARVARD COMMERCIAL BUILDING, 105-111 THOMSON ROAD, WAN CHAI, HK
Supplier`s last login times:
within 11 hours
Product Details
Company Profile
Product Details
AS/NZS 3112:2017 Test Device for Securement of pins for
Australian/NZ Plugs and socket-outlets
AS/NZS 3112:2017 Clause 2.13.9 Test Device for Securement of pins
2.13.9 Securement of pins
2.13.9.1 Movement of pins
Plugs shall be tested for pin movement by clamping the pin or pins
not under test in a rigid holding block positioned 5 ±0.5 mm from the plug face and applying
a force of 18 ±1 N to the pin under test. The design of the block shall be such that the
pin under test shall not
come into contact with the block during the test.
Except for non-rewireable plugs, the test shall be carried out
without a cord attached to the plug, and with the terminal screws loosened sufficiently to allow a
1 mm2 conductor to be connected.
The plug and test equipment shall be preconditioned at a
temperature of 40 ±1°C for 1 h,without the test force applied. Throughout the test, all parts of
the plug and test equipment shall be maintained at this temperature.
For all plugs, the point of application of the force shall be 14
±0.5 mm from the face of the plug along the pins, and the direction of the force shall be—
(a) in both directions along the line perpendicular to the plane of
the pin, and passing
through the centre of the pin; and
(b) in that plane in both directions along a line at right angles
to that specified in
Item (a).
Over a period of 10 s, the force shall be gradually applied to each
of the pins in the manner prescribed in Items (a) and (b), maintained at its maximum value
for 10 s, and then released. The deflection of the pins shall be measured along the
line of force relative to the
face of the rigid holding block during the period when the force is
applied. The maximum deflection shall not exceed 2.0 mm.
Following the test on all pins of a plug conforming to Figure 2.1,
any distortion 5 min after the completion of the test on the last pin shall be such that it
will not prevent the plug from being inserted in the appropriate standard gauges shown in Appendix
A, Appendix B and
Appendix F without the application of undue force.
For other types of plugs, any distortion after 5 min shall be such
that will not prevent the plug being inserted into an appropriate socket-outlet without the
application of undue force.
Securement Of Pins Australian/NZ Plugs And Socket Outlets AS/NZS 3112:2017 Test
Inquiry Cart
0