Ethanol / CNG Compressed Air Storage Tank , 8mm Thickness Air Compressor Holding Tank

8mm compressed air tank for storage ethanol , CNG , Glp / air compressor holding tank

1. Company Profile

Shanghai Fengxian Equipment Vessel Factory was founded in 1982, and specializes in designing and manufacturing all kinds of pressure vessels. We have a high profile in the industry. And in 1998, we registered the brand of “Shen Jiang”. Our pressure vessels are widely used in petroleum, chemical, electronic, automotive, power generation, mining, pharmaceutical and other industries. Look forward to the cooperation with you in the increasingly powerful of our company.

2. The important of compressed air tank plays in air compressor system ?

An air receiver tank is an integral and important part of any compressed air system. Typically a receiver tank is sized at 6-10 times the flow rate of the system. So, if a compressor has a rating of 25 cfm at 100 psi, the receiver tank should be 150 cubic feet, minimum. In a compressed air system, a receiver tank provides the following benefits:

• The receiver tank acts as a reservoir of compressed air for peak demands.
• The receiver tank will help remove water from the system by allowing the air a chance to cool.
• The receiver tank minimizes pulsation in the system caused by a reciprocating compressor or a cyclic process downstream.

Much like a water reservoir provides water during times of drought and stores water during the wet times, an air receiver tank compensates for peak demand and helps balance the supply of the compressor with the demand of the system.

Receiver tanks are required by law to have a pressure relief valve and a pressure gauge. The relief valve should be set to 10% higher than the working pressure of the system.

It is also important to install either a manual or automatic drain on the receiver tank to remove water from the system.

2. Product Specifications

3. Product advantages

4. Our Advantages

5. Our Clients

BAOSTEEL, TOSHIBA, CONCH, SPC, DAS AUTO, CHINA SHENHUA, HONGTA GROUP, FOXCONN,

BMW, CSIC, WALT DISNEY, BOSCH, ANSTEEL, SINOMA, etc.

Shanghai Fengxian Equipment Vessel Factory is approved by the State Administration of Quality Supervision, Inspection and Quarantine, with the design, manufacture D1, D2 pressure vessel capacity of professional units. The factory is located in the South Shanghai, No. 2108 Hangzhou Highway, Nanqiao Town, Fengxian District.

Our factory covers an area of nearly 66,000 square feet, over 300 employees, more than 70 engineering and technical personnel. There are dozens of large equipment such as 9M planing machine, 2.5M plate lathe, cross arm automatic welding machine, 300 tons hydraulic press and so on. After years of efforts, our factory has achieved production scale, testing standardization, and gradually to the mechanization and automation development.

Our factory products use "Shenjiang brand" trademark registration, and the formation of more than 100 specifications series of gas cylinders. Design and manufacture for various non-standard pressure vessels, abrasive barrels, reaction vessels, filters, separators, heat exchangers, muffler , Sub-cylinder, tank, sink. Widely used in petroleum, chemical, electronics, automobile manufacturing, power generation, mining, pharmaceutical and other industries. Product marketing more than 20 provinces, cities and worldwide.