Mica Wire Slotting Slot Insulation Machine Single Chip Control Motor Armature Commutator
Brand Name:WIND AUTOMATION
Model Number:WIND-FD-8066
Minimum Order Quantity:1pc
Delivery Time:35 working days
Payment Terms:T/T
Place of Origin:China
Contact Now
Add to Cart
Verified Supplier
Location:
Shanghai Shanghai China
Address:
No.4 Building , No.388, Kongjiang Road,Yangpu District,200093,Shanghai,China
Supplier`s last login times:
within 36 hours
Product Details
Company Profile
Product Details
Singlechip Control Motor Armature Commutator Mica Wire Slotting Machine
(1) Technical Data
Voltage: three phase 380 V,50Hz
Air source: 0.4 to 0.75MPa
Motor power: 1.1kw
Commutator OD range from 5mm to 130mm
Speed: 2800RPM
Capability in one shift: 1200 pcs
Slot range: 2 to 99 slot
(2) Competitive Advantages
The commutator slotting machine can handle commutator type with slotted type and hook type
commutator with OD range from 5mm to 130mm
(3) Auomated or Semi auto device choise
For slotted type commutator without riser, automated system is suitable,
For hook type commutator, slotting process is before bend the hook end
(4) Attention points
During the commutator slotting process, splashed copper chips are mixed in the air around the controller.
These chips of copper cut the circuit board and components of the controller at all times and cause a
short circuit between the wires! If an abnormal situation occurs during work, immediately stop working and
switch off the power quickly. Then use 4-6kg / cm pressure of dry compressed air blow off the control
board and the drive board copper cutting powder, make sure the circuit board and components without
copper cutting powder, and then restart the work.
Touble shooting:
Question:
It appears that the new commutator slotter is malfunctioning and I believe it is a programming issue. The
unit has been used for production for 5 days until today. For some reason, the plc does not stop the saw
and plate inverter once the last cut has been made. How do we get support from Shanghai Wind to get
this issue resolved?
Answer:
Would you please take a long video to for us to check the problem ' plc does not stop the saw and plate
inverter once the last cut has been made'?
The issue is caused by signal interference, please follow below
step to solve it,
1. Switch off the machine, wait for 1 minutes
2. Power on the machine
3. Press ▲ button for 5 seconds to machine intial setting
You may take a photo of the screen for us to confirm after you go
to the machine intial setting,
To start the operation again, please do the optical detection,
below is the steps for 'Optical detection for
initial setting'
1. Press the second ⊙ round button
2. then press ▲ three times
3. and then press +
Also there is a video for reference, IMG_5551 Optical detection for initial setting of new commutator type
Mica Wire Slotting Slot Insulation Machine Single Chip Control Motor Armature Commutator
Inquiry Cart
0