ATTINY48-MU Microcontroller IC 8 Bit 12MHz 4KB 2K x 16 Flash 32- VQFN 12MHz Speed

ATTINY48-MU Microcontroller IC 8-Bit 12MHz 4KB (2K x 16) FLASH 32-VQFN

Features

• High Performance, Low Power AVR® 8-Bit Microcontroller

• Advanced RISC Architecture

– 123 Powerful Instructions – Most Single Clock Cycle Execution

– 32 x 8 General Purpose Working Registers

– Fully Static Operation

• High Endurance Non-volatile Memory Segments

– 4K/8K Bytes of In-System Self-Programmable Flash program memory(ATtiny48/88)

– 64/64 Bytes EEPROM (ATtiny48/88)

– 256/512 Bytes Internal SRAM (ATtiny48/88)

– Write/Erase Cycles: 10,000 Flash/100,000 EEPROM

– Data retention: 20 years at 85

°C / 100 years at 25°C

– Optional Boot Code Section with Indepentent Lock Bits

• In-System Programming by On-chip Boot Program

• True Read-While-Write Operation

– Programming Lock for Software Security

• Peripheral Features

– One 8-bit Timer/Counter with Separate Prescaler and Compare Mode

– One 16-bit Timer/Counter with Prescaler, and Compare and Capture Modes

– 8-channel 10-bit ADC in 32-lead TQFP and 32-pad QFN/MLF package

– 6-channel 10-bit ADC in 28-pin PDIP and 28-pad QFN/MLF package

– Master/Slave SPI Serial Interface

– Byte-oriented 2-wire Serial Interface (Philips I2C Compatible)

– Programmable Watchdog Timer with Separate On-chip Oscillator

– On-chip Analog Comparator

– Interrupt and Wake-up on Pin Change

• Special Microcontroller Features

– debugWIRE On-chip Debug System

– In-System Programmable via SPI Port

– Power-on Reset and Programmable Brown-out Detection

– Internal Calibrated Oscillator

– External and Internal Interrupt Sources

– Three Sleep Modes: Idle, ADC Noise Reduction and Power-down

• I/O and Packages

– 28 Programmable I/O Lines in 32-lead TQFP and 32-pad QFN/MLF package

– 24 Programmable I/O Lines in 28-pin PDIP and 28-pad QFN/MLF package

– 28-pin PDIP, 32-lead TQFP, 28-pad QFN/MLF and 32-pad QFN/MLF

• Operating Voltage:

–1.8– 5.5V

• Temperature Range:

–-40°C to +85°C

Koben Electronics was founded in 1995 and is located in the Silicon Valley of China, Shenzhen.

The mission of Koben has always been to provide quality electronics components to manufacturers worldwide. Early on we became a primary conduit for end-of-program and overstock inventory for major distributors such as Future Electronics and contract manufacturers as Flextronics. Koben has since then added sourcing of high quality components from local manufacturers in China.

Koben has always been customer driven rather than opportunity driven. Meaning- we will always choose path that is best for long term relationship with customer over short term view. It is why we have one of the highest customer retention scores of China based distributors.