40KA power surge protector three phase SPD c40 surge protective device

2P lightning protector household lightning protection Max continuous operating voltage 275V

Working principle of product

Surge protector and its voltage limiting functional element are composed of metal oxide varistors in parallel. Each varistor requires an independent disconnector. The principle of the disconnector is a heat release. The function is disconnected through the low temperature welding point and is separated from the metal rod by its own elastic action. After disengagement, the red indication will appear in the transparent window on the front side of the surge protector. It is installed in the main power distribution cabinet and outdoor power distribution cabinet.

Product features

1. troubleshooting automatic reset

2. use the pluggable module set up, the maintenance is simple

3. leakage current is small, the response time is fast, and the residual pressure is low
Four

Product specification

Product introduction

Surge protector is the lightning protection measures taken by Zhejiang toer Electric Co., Ltd. for its own development and production. When equipment short circuit and power switching are likely to cause surge, the surge occurs in only a few millisecond time, which will have great harm to the equipment. The surge protector can react and effectively absorb the huge energy of burst at this time, so as to protect the connecting devices from being damaged.

Use of attention

1. connect the grounding wire of the lightning protector with the ground wire of the lightning protection system.

2. it should match the working voltage of the protected equipment. Please install according to the installation sketch.

3. this product needs no special maintenance. The lightning arrester should be checked regularly, especially in the thunderstorm season and the whole thunderstorm period. When the system fails to doubt the lightning arrester, the lightning arrester can be dismantled and rechecked. If the system is restored to normal after the restoration to the state before use, it indicates that the lightning arrester has been damaged and must be replaced immediately.

Company profile

Thor has been designing new products to meet the RoHS directive since 2006. Thor’s ongoing commitment to RoHS compliance includes continuing efforts to reduce the presence of hazardous substances in the design and manufacture of a growing number of popular products.
All types and classes of our lightning and surge arresters 20KA~200KA(8/20μS) and 15KA~50KA(10/350μS) are tested and pass all the requirements based on their class.

Thor is all about protecting against the damaging effects of power transients. It is our goal and mission to connect our customer challenges with high-quality, right-priced solutions and products – completed by unrivaled customer service and technical support.

Incorporated in 2006, Zhejiang Thor Electric Co., Ltd has built everything to offer a wide range of innovative and reliable surge protection solutions and products.

Thor is following the international quality system standards, is ISO 9001 certified and our technical standards are in line with GB18802.1-2011/IEC61643-1.

All types and classes of our lightning and surge arresters 20KA~200KA(8/20μS) and 15KA~50KA(10/350μS) are tested and pass all the requirements based on their class.

Thor has been designing new products to meet the RoHS directive since 2006. Thor’s ongoing commitment to RoHS compliance includes continuing efforts to reduce the presence of hazardous substances in the design and manufacture of a growing number of popular products.

Zhejiang Thor Electric Co., Ltd is committed to meeting the requirements of the European Union’s Waste Electrical and Electronic Equipment (WEEE) directive. This directive requires producers of electrical and electronic equipment to finance the take-back for re-use or recycling of their products placed on the EU market after 2005.