High Standard Coaxial Cable Surge Protector F Interface Short Reaction Times

Brand Name:THOR
Certification:CE
Model Number:TRSW-F
Minimum Order Quantity:1 piece
Delivery Time:3-7 work day
Payment Terms:L/C, T/T, Western Union, MoneyGram
Contact Now

Add to Cart

Active Member
Location: Wenzhou Zhejiang China
Address: China Zhejiang Wenzhou Economic Development Zone
Supplier`s last login times: within 36 hours
Product Details Company Profile
Product Details

F interface type antenna coaxial lightning arrester diamond CA-23R outdoor antenna lightning protection device


Brief introduction


The F interface lightning protector is a design of lightning protection applied to the antenna feeder system based on the relevant standards. It is suitable for the surge protection of the coaxial sky feed system signals such as satellite wireless communication, mobile base station, microwave communication, radio and television and so on, to prevent the damage caused by the feeder line induced lightning overvoltage on the antenna and the transceiver.



Product features


Model and specofocation TRSW-BNC
Frequency range DC-1.5 GHz
Working voltage 500V
Nominal discharge currentIn(8/20μS)10kA
Insulation resistance ≥5000 MΩ
Dielectric withstanding voltage 1500V
Impedance 75Ω
Interface mode BNC.N.UHF.TNC and so on
Operating condition Temp:-40℃~+70℃
 RH≤95%(25℃)
 Sea level elevation≤3km
Remarks Other max continuous operating voltage can be customized

Use of attention


1. identify the input / output interface identifier of the lightning protector, input the external line and output the connection device.


2. when a signal transmission failure occurs on the line, we should find out the reason. If the lightning protector is damaged, the lightning protector will be changed immediately.


3. the wire on the lightning arrester is welded to the shortest grounding wire (the wire area is not less than 2.5mm2), the other end is connected to the grounding bus of the lightning protection system, and the grounding resistance is not more than 4 Omega.


4. this product for F interface does not apply to the external interface



Working principle of product


The lightning protection device is based on the principle of standing wave antenna and lightning wave spectrum design. The main part is a short rod equivalent to the end of the 1/4 wavelength. When the signal is sent out, a part of the impedance is reflected back because the impedance is not fully matched, and the wave will form a standing wave when the wave is superimposed on the incident wave originally emitted. The amplitude of standing wave at each point of the line is fixed first. For the transmission line with terminal short circuit, the terminal is short circuited, so the current is large and the voltage is small. For the signal end, the voltage and the current are small.
That is, the most close to the open circuit of the signal terminal impedance, so the loss is small, but for the lightning wave because of its wide spectrum range, and most of the energy is concentrated in the frequency band below 10HZ, so the short circuit rod is short circuited to the lightning, and will not invade the equipment to cause damage.


Company profile


Thor is all about protecting against the damaging effects of power transients. It is our goal and mission to connect our customer challenges with high-quality, right-priced solutions and products – completed by unrivaled customer service and technical support.

All types and classes of our lightning and surge arresters 20KA~200KA(8/20μS) and 15KA~50KA(10/350μS) are tested and pass all the requirements based on their class.

China High Standard Coaxial Cable Surge Protector F Interface Short Reaction Times supplier

High Standard Coaxial Cable Surge Protector F Interface Short Reaction Times

Inquiry Cart 0