White Viscous Liquid Gray Cationic Electrodeposition Paint For Agricultural Machinery

Product Introduction :

This product features shown below: 

①,The appearance of the coating is flat, delicate, smooth.



②,Good stability of bath can adaptable for a longer updating cycle. 

③,The bath has strong anti-shrinkage and anti-pollution ability.



④,High penetration and good uniformity of internal and external. 

⑤,Good weather resistance, very suitable for car body, car chassis, electric, three wheeled motorcycle frame and other industries.

The main component Matrix resin:

Filling tank proportion and method :

⑴ Bath preparation

Ratio:

Resin 1400.00

Paste 233.00-175.00

NHF-01 10.00

DI water 1785.00

Total 3428.00-3370.00

⑵ Ripening conditions

Sample quantity: 3000～4500g
Container: 5L (Diameter 16cm)

Tank temperature:30 ±2℃

Time: 24～48Hr

Mixed conditions: impeller diameter 8cm (speed 200rpm)

(3) Coating conditions

Experimental panel: phosphated cold-rolled steel plate

Tank temperature: 28-35℃

Pole ratio: A/C = 1/2 ~ 1/4

Distance of electrodes: 15cm

ED time: For full immersing 1-3 minutes ( 20 seconds soft start)

Baking conditions:(165-175)℃×(20-30)min (Keeping temperature of parts coated)

Storage, packaging and transportation :

This product is a water-borne industrial coatings, non-hazardous, non-inflammable and explosive products; transportation to prevent direct sunlight, avoid freezing (>5℃ ); Packaging for 50/60/200L Plastic barrel; in the transport and storage of drums should be maintained clean, avoid charging the dirt brought in on drums during filling tank, again checked and confirmed that the quality of products, including paste resin, emulsions and additives should be indoor storage, good ventilation, dry, protect against freezing and overheating, the storage temperature should be controlled at 5～35℃, products from the date of production, over shelf, experimentation is required to determine whether can continue to use.