

Add to Cart
Hand-held 3 bands vehicle-mounted car CDMD GSM DCS jammer mobile Handheld Signale Jammer
Product Fetures:
Product Applications:
Product Specification:
Project | Characteristic Parameter |
Type of action device. | Satellite navigation, tracking and so on. |
Maximum radiation power (1 m, dipole antenna test) | Under -10dBm |
Transmitting Frequency | CDMD/GSM DCS GPS |
Power Range | 33dBm 6dBm/30KHz (min) |
Effective Coverage Range(jamming radiuss) | 2--15m |
Size | 95x45x20 mm |
Charging specification | Input:110V-240V Output:4.5V |
Weight | About 0.36kg |
Working Temperature | -30~60℃ |
Relative Humidity | 5~95% |
storage temperature | -50~+60℃ |
Product Image:
FAQ:
Is there any difference between the effective shielding distance of
the mobile phone signal shield in indoor and outdoor use?
A: There are.The effective shielding distance (30-40 meters) of the
cell phone signal shield is generally referred to as indoor
distance.In open areas, the effective distance of shielding can be
several hundred meters.It should be noted, whether they are within
the room, or in outdoor use, effective shielding effect of
shielding distance has relationship with environmental conditions,
such as from the base station near and far, placed, etc.Therefore,
when using cell phone signal shield, this factor should be fully
taken into account to avoid blocking the dead Angle and thus affect
the shielding effect.
Is the cellular signal shield the same for GSM mobile phones and
CDMA mobile phones?
A: that's a good question.Because CDMA mobile phone's
anti-interference performance is far superior to that of GSM mobile
phone, the effective shielding distance for CDMA mobile phone is
smaller than that of GSM mobile phone, but the difference is not
very large, about 2-4 meters.But it also reminds users to pay
attention to some particularly important sites, and should increase
the number of mobile phone signal blockers when necessary to ensure
the shielding effect of CDMA mobile phones.
After working for a period of time, the mobile phone signal mask is
hot. Will working long hours damage the machine?
A: thank you for your care. This is a normal phenomenon.In the
design, we use the thermal conductivity of aluminum alloy to assist
the heat dissipation.This can guarantee long time stable work.As a
result, the machine will not damage the machine.
Advantages
1: All in one with 20 chancel design, Customized for special
frequency range
2: High output power, Total up to: 45W , jamming up to 40m (Still
depends on the strength signal in given area)
3: External Omni-directional antennas all the TX frequency covered
down link only
4: With Car storage battery Charger DC12V can be used in car
5: Built-in good cooling system inside, Working non-stopped
6: Can adjust or turn off any single band without influencing the
other bands operation
7: Independent module design with frequency source of each channel, easy maintenance (if have any damaged frequency band, replace with new PCB directly, no need for professional equipment such as frequency analyzer)
8: 2-5meters with Infrared Remote Control Turn ON /OFF Power