Durable Hydraulic Pipe Cutter And Beveler Climbing Style Compact Design

Features

■ Perfect cold cutting

It has been used in a wide range of applications, including natural gas, crude oil and radioactive environments

■ Compact & portable design

Light weight, only 10"-12"gap, less than 10 minutes to install

■ A wide range of applications

Operate in the trenches full of silt and 25 meters underwater and available for cutting and beveling in flooded trenches and underwater mud at 600 feet.

■ Good stability

Strong corrosion resistance and durable structure

Technical Parameters

Chain Length

Operating Instructions

■ After the pipe is cut half, insert the steel wedge into the slit of the cut pipe to prevent the pipe from clamping.

■ Sharp cutters will ensure safe, accurate, dependable cuts. Please carefully observe whether the cutting tool is sharp before cutting.

■ The cutting condition will be drier when cutting cast iron and ductile iron pipe. Usea thread cutting oil or a water soluble cutting oil on steel and stainless steel pipe to lubricate the cutters and help maintain sharpness.

■ Use specialized guide track when cutting in a vertical position or when exact accuracy is required.

■ Adjust the feed rate to reduce or eliminate cutter overload. Feed valve must be opened very slowly to achieve a slower feed rate. For complete control of feed speed, install throttle valve in the feed line.

■ The maximum effective cutting rate for the Travel Cutter on ductile iron is approximately one minute per inch of diameter. Some cast iron, steel, heavy wall pipe and beveling will require a slower feed rate.

Notes

Maintenance Information: Before the machine or any of its accessories is returned for maintenance, please call Bohyar Company. We will give suggestions on transportation and handover of the machine or accessories, and estimate the time and cost of corresponding maintenance.