Add to Cart
Product Description
Adhesive Fiber glass Mesh Tape is woven from C-fiberglass yarn, then coated with adhesive acrylic latex.Save
considerable time and eliminate one step of mudding when combining the self adhesive mesh tape with a setting compound. This product has good performances like good softness, high stickiness, and easy application.Used to cover seams in the process of drywall construction, also be used to wall and ceiling problems, seal corners where two sections of drywall meet.
Specification
Density | 65±3g/㎡ | 75±3g/㎡ |
Raw Fabric | 45g/㎡ | 55g/㎡ |
Glue Content | 30% | 30% |
Glue Type | Adhesive latex | Adhesive latex |
Moisture | 0.5% | 0.5% |
Mesh Size | 8*8/inch | 9*9/inch |
Tensile Strength | 600n/50mm | 600n/50mm |
Supply Ability
10000rolls per day
Packing&Delivery
Each roll with pvc shrink packaging,24rolls ,36 rolls or 72rolls per carton
Application Method:
The use is easy and fast, no pre-plastering required, no bubbles.
It is used to cover or repair joints, cracks and holes on walls,
roofs, etc.
1. Wall must be clean and dry.
2. Center and apply tape over the length of the joint and pressing
firmly.
3. Apply a generous first coat of compound over the tape and
through the mesh, making sure to completely fill the joint crevice.
When the joint has been completely filled, wipe off any excess
compound with the drywall knife leaving enough fill the joint
crevice. Let dry completely ,then sand slightly.
4. Apply sufficient thin finishing coats to produce a smooth wall
surface.
5. Cut of butted do not have a tapered edge. Therefore, special
care must be taken to assure proper compound that will require an
increased amount of edge feathering.