plate heat exchanger Fischer E-18 thickness 4.4mm gasket centre size870*122mm

Special model chemical industry widegap channel corrugated plate heat exchanger Fischer E-18

E18 Plate Heat Exchanger Introduction

E18 plate heat exchangers are specifically developed and optimized for the food industry. A v ery wide range of different systems can be offered. Plate surfaces from 0.05㎡ to 1.5㎡ and throughputs up to 500m³/hr are available.

E18 Plate Heat Exchanger Gasket And Plate Parameter

E18 Plate Heat Exchanger Advantage

How to install E18 Plate Heat Exchanger When Maintance?

1 Disconnect pipework from pressure plate
• disconnect pipework from pressure plate
Taking Out Heat Exchanger Plates
• remove the nuts (12a) versus clockwise
• losen all nuts for tensioning bolt (12) crosswise
• unscrew nuts for tensioning bolt (12) from tensioning bolt (1)
• remove washer for tie bar (13)
• remove tensioning bolts (1)
• push pressure plate (10) away from plate pack
• swing out first heat exchanger plate at bottom 20 - 30 cm in longitudal
direction [1]
• swing out plate laterally under an angle of
30 - 45° [2]
• take the plate off the frame
• remove plate by plate in the same manner
• observe the sequence and face position of plates - after cleaning they must be
installed back the same way

2 Cleaning of Heat Exchanger Plates

• rinse each plate with a suitable detergent (must neither attack gasket nor plate) information about suitable detergents can be obtained from Heat Exchanger manufacturer

• clean plates with a soft brush

• gaskets not to be exchanged:

- avoid soaking of plate in cleaning solution

• gaskets to be exchanged:

- soak plate in hot cleaning solution (approx. 100°C)

• at thick layers of scaling :

- soak plate in hot cleaning solution (approx. 100°C)

DO NOT use:

- steel brush

- steel scraper or similar

3 Re-assembling

• re-install again the cleaned plates

observe

- original sequence and position of each plate (as per numbers and plate arrangement drawing)

- gaskets installed and in good order

• fit individual plates (lateral insertion under 30 - 40°inclination)

• push pressure plate (10) to the plate plack

• re-insert tensioning bolts (1) back in lateral slots

• fit washers for tensioning bolt (13) to the tensioning bolts (1)

• tension the plate pack with the nuts for tensioning bolt (12)

- uniformly

- crosswise

- observe parallelism between pressure plate (10) and frame plate (4)

• observe tesnioning limit on name plate

• avoid:

- overtensioning (below min. tensioning limit on name plate)

- too little tensioning (above max. tensioning limit on name plate)

• fix the nuts for tensioning bolt (12) by mounting the nuts (12a)

• connect pipework again

• start up Heat Exchanger as per section 6

Jiangyin M&C Heat Parts Co.,Ltd is a China heat exchanger manufacturer located in Wuxi, Jiangsu. M&C performing service and maintenance on heat exchanger gaskets and plates for other models.

M&C operates at the forefront of thermal technology,offering innovative and effective heat transfer products worldwide with a strong focus on managing energy efficiently

M&C specialise in the design and manufacturer of a wide range of heat exchangers for industrial, food,dairy,agricultural,hygienic,refrigeration,HVAC and marine applications.

Over these years, M&C has been developing new types of heat exchangers and committed to working closely with our customers to delivery step by step improvement. We’re proud to operate in a setor where innovation can save energy,reduce waste and improve final product quality without harming the enviroment.

We have professional technical teams to support our products innovation and quality control.

Welcome to visit our plants, and have win-win cooperation together!

Human-oriented, Integrity deelopment, Qulity first, Service sincerely.