Disc Stack Centrifugal / Waste Oil Separator Machine 5000L/H Capacity

Disc Stack Centrifugal / Waste Oil Separator Machine 5000L/H Capacity

Introduction:

Zydh can separate rapid succession of solid liquid and liquid liquid ,which is a kind of vertical centrifuge. A rotary drum is install in the upper end of vertical shaft, the driving device driven by a motor to rotate at high speed. Drum have a set of a butterfly shaped parts mutually overlapped together. Have a very small space left between the disc and disc. Suspension pour into drum by feeding tube which is located center of the drum.When the slurry flows past the clearance between the disc, solid particles in centrifuge sinking to the sediment is formed on the disc. Sediment falls of the disc along the sliding surface of the disc and accumulate in the drum at the largest diameter. The separation of the liquid exhaust drum from the liquid outlet .The function of the disc is to short the distance between the settlement of solid particles or liquid droplets and to expand the area of settlement of the drum.Because the installation disc in the drum and greatly improves the separators’ production capacity.

Feature:

Separator has many advantages, such as separation factor high, running balance, simple operation, low oil consumption. In order to meet different requirements of production scale, the machine adopt bottom washing. Facilitate liquid seal and exclusive soap, the heart pump discharge the material, reducing system operating pressure. Regulate different specific gravity ring, can be suitable for all kinds of oil, so that better separation.

Techincal Parameters :

Main parts:

Main parts 1. Access device 2.drum 3.paring disc device 4.drive system 5.stainless steel cover 6.engine base 7.Motor

(1). Machine starts the friction to start off, about six to ten minutes. The machine runs smoothly, low noise and vibration, the installation path is very easy to operate.

(2) The main strengthen parts of Roller body and Roller cover use 2Cr13, and the other parts of contacted materials such as Disc all use 316L

(3) The Stainless steel cover use SUS304

(4) The base use casting steel, coating does the same way as ship bottom.