

Add to Cart
EN 1492-2 Endless Polyester Round Slings , Flexible Soft Round Lifting Sling Safety Factor 7:1
Product Name | Round sling |
Material | Polyester |
Standard | European Standard EN1492-2:2000 and Chinese Standard JB/T8521-2007 |
Capacity | 1t~3000t |
Size | 1m-100m |
Features | *Highly flexible and adaptable to given shapes, especially suitable
for loading round objects *Anti-abrasion and anti-incision protection sleeve can be attached *Heat resistant up to 100°C *High strength/weight ratio *Usage life last longer *Protection against cargo surface damage *Safety factor: 5:1, 6:1, 7:1, 8:1 |
Packing | Carton, wooden case or according to your requirement |
Delivery Time | 20-40days, based on Qty |
Application | lifting, loading &unloading, pipe laying |
Capacity
The sling must be both long enough and strong enough for the load
and the slinging method. Apply the mode factorfor the slinging
method. For use at temperatures exceeding 80°C or below 0°C refer
to the suppliers instructions. Ifthe slings are used in multi-leg
arrangement the angle formed between the legs should not be less
than 30° orgreater than 90°. If abrasion, heat generated by
friction or cutting from edges or corners are likely, select a
slingfitted with protective sleeves and/or use suitable packing.
In-service Inspection, Maintenance and Replacement
Inspect slings each day before use, looking for:
Do not use worn or damaged slings or attachments. Discard or repair
them. Use damaged slings only after they are repaired,
reconditioned, and proof tested by the sling manufacturer or a
qualified person. Keep certificates of proof test.
Maintenance requirements are minimal. Belt slings may be cleaned
with clear water. Remember weak chemical
solutions will become increasingly stronger by evaporation.
Regularly inspect belt slings and, in the event of the
following defects, refer the sling to a Competent Person for
thorough examination: illegible markings; damaged,
chaffed or cut webbing; damaged or loose stitching; heat damage;
burns; chemical damage; solar degradation;
damaged or deformed end fittings.