Car Rubberized Undercoating / Automotive Rubberized Undercoating Spray 500ml / 1L

Features:

1. Environmental protection, convenient application.

2. Durable protective layer on the car chassis against being rusted and eroded.

3. Good performance on sound insulating and noise reducing.

4. Widely applied in the auto manufacturing.

5. Provides hiding power,abrasion resistance,corrosion protection to:

Automotive undercarriages,Wheel wells,Door skins,Trunks,Floor pans,Inside body panels and other

automotive applications for the tasks mentioned above.

Directions:
1, clean the surface which you will need to spray.
2, Repeated shaking of the products 1 to 2 minutes, the contents were shaken.
3, Pressing the nozzle,towards the surface at a distance of 10 to 25 cm forth spray evenly. If large particles should be erased, partial fill spray.
4, It often need to spray 5 ~ 6 times, at intervals of 1-2 minutes coating layer, in order to ensure that each layer was dried, to achieve the best results.
5, All the construction is completed naturally dry 4 to 8 hours, two days cleaning and wading is not recommended.
6, The winter cold construction in case the spray is not normal, you can put spray cans at 18-28ºC warm water soak for 5 to 10 minutes before the construction.
7, If the spray is not used up, upside down for 3 seconds to clear the nozzle I film, and then upright storage.

Note:

1. Before spraying, adequate shelter around the surface where do not need to spray.
2. Spraying aerosol cans must be maintained with the horizontal angle of not less than 45ºC.
3. Avoid contact with eyes, avoid inhalation.
4. After spraying the surface to avoid contact with gasoline and diesel, alcohol, thinner or other solvents like liquid.
5. In a cool dry place, away from sources of ignition heat, avoid squeezing collisions.
6. Keep away from children, disabled ingested.

Competitive Advantage:

1. Fashionable plastic coating Plasti Dip spray
2. Protection against dirt
3. Waterproof
4. Content: 400ml per can

5. Fast drying

6. Wash resistant
7. Sustainable
8. Removable