3 Bins Industrial Ultrasonic Cleaner 28/40KHz For Surgical Knife Blade / Tools

3 Bins Ultrasonic Cleaner for Surgical knife blade/tools with Rinsing, Filter, Dryer 38L

Specification

Suggested Ultrasonic Cleaning Procedure

In all cases manufacturers’ instructions should be followed when using an ultrasonic cleaning process. These are representative steps.

Fill the ultrasonic cleaning tank with an approved medical instrument cleaning solution such as CLN-LR012 available from Tovatech following dilution instructions provided. Turn the cleaner on to start the degassing process. This step removes entrained air in new solutions that interferes with the efficiency of cavitation and takes approximately 10 minutes.

In the meantime:

Segregate instruments by alloy or composition to avoid potential damage (Chromium plated instruments should not be cleaned ultrasonically)

Instruments with movable parts should be disassembled to facilitate cleaning

Place the instruments the ultrasonic cleaner’s mesh basket, taking care that they do not come in contact with each other
Cannulated or lumened instruments should be positioned to insure interiors are wetted with the cleaning solution. In some instances placing them on an angle will facilitate this

Set the control panel per manufacturers’ instructions and start the cleaning process

At the end of the cycle, remove the instruments from the ultrasonic cleaning bath and thoroughly rinse them to remove all traces of the cleaning solution. Deionized water rinses will avoid spotting. If the instruments are not to be immediately disinfected and sterilized be certain that they are thoroughly dried and protected. Part reassembly can occur after sterilization.

Procedures should be in place to guide the replacement of used ultrasonic cleaning solutions. In some instances it is recommended that solution be drained and tanks thoroughly cleaned and dried after each ultrasonic cleaning cycle. Most solutions available today are biodegradable, which facilitates disposal but local authorities should be consulted on proper practices.

Same series with different size for your choice:

Images:

Clean effect:

How do I know what size of ultrasonic cleaner is best for my operation?
The two points you should think about,

● How about your cleaning volume? For very little small part, a table top ultrasonic are able to do this job. For large size and huge volume, you should consider industrial ultrasonic cleaner , for highest cleanness level , multi-stage ultrasonic cleaning system are recommend.

● The size of cleaning object, it can fit in the basket fully immersed under water.

History:
Skymen Cleaning Equipment Shenzhen Co., Ltd., was founded in 2007,which follows the brand development strategy of “based in Shenzhen, radiating throughout the country, expanding overseas”.
Skymen also owns a professional R&D team to keep the pace with international ultrasonic technology. A passionate and young sales team sell to the world through different channels.

Skymen Technology Corporation Limited, which is a leading manufacturer and national high-tech enterprise, was founded in 2007. There are 2 factories of Skymen, one is located in Shenzhen, closed to HongKong. And the other is located in Shaoguan, Guangdong province, China.

We have been focusing on R&D of ultrasonic equipment & cleaning solution for more than 17 years with over 300 employees and plant size 39,000 square meters. Products include CE, FCC, PSE, KC and other safety certification, as well as ROHS,PAHS, REACH, SCCP environmental certification, and passed the factory audit BSCI, ISO9001 quality management system.

There are more than 200 patents & certificates in total. Our products range covers industrial ultrasonic cleaner, homeuse ultrasonic cleaner, commercial ultrasonic cleaner, full-automatic ultrasonic cleaning machine, ultrasonic transducer rod series, ultrasonic transducer plate series, tunnel cleaning machine, large hydrocarbon ultrasonic cleaning equipment with PLC, large ultrasonic cleaning equipment with vacuum implementation, etc.

2023 Skymen self-built Shaoguan industrial Park

2020 New Factory Industrial Park

Shenzhen R&D Basement

Shenzhen Marketing Center