Photo Mosfet Power Module PCM Remote Control Systems Output Active Low

Brand Name:VISHAY
Certification:Original Factory Pack
Model Number:HS0038A4
Minimum Order Quantity:20
Delivery Time:1
Payment Terms:T/T, Western Union,Paypal
Contact Now

Add to Cart

Site Member
Location: Shenzhen Guangdong China
Address: Room 36B1-B2, Building C, Electronics Science & Technology Building Shennan Mid-Road, Shenzhen China
Supplier`s last login times: within 25 hours
Product Details Company Profile
Product Details

Photo Mosfet Power Module PCM Remote Control Systems Output Active Low


Photo Modules for PCM Remote Control Systems


Description

The HS0038A2. – series are miniaturized receivers

for infrared remote control systems.

PIN diode and preamplifier are assembled on lead frame,

the epoxy package is designed as IR filter.

The demodulated output signal can directly be decoded

by a microprocessor. HS0038A2. is the standard

IR remote control receiver series,

supporting all major transmission codes.


Features

1. Photo detector and preamplifier in one package


2.Internal filter for PCM frequency Improved shielding against electrical field disturbance


3.TTL and CMOS compatibility


4.Output active low Low power consumption


5. High immunity against ambient light


6.Continuous data transmission possible (800 bit/s)

Suitable burst length ≥10 cycles/burst


Block Diagram

Absolute Maximum Ratings Tamb = 25C

ParameterTest ConditionsSymbolValueUnit
Supply Voltage(Pin 2)VS–0.3...6.0V
Supply Current(Pin 2)IS5mA
Output Voltage(Pin 3)VO–0.3...6.0V
Output Current(Pin 3)IO5mA
Junction TemperatureTj100C
Storage Temperature RangeTstg–25...+85C
Operating Temperature RangeTamb–25...+85C
Power Consumption (Tamb 85 C)Ptot50mW


Suitable Data Format

The circuit of the HS0038A2. is designed in that way that unexpected output pulses due to noise or disturbance signals are avoided. A bandpassfilter, an integrator stage and an automatic gain control are used to suppress such disturbances. The distinguishing mark between data signal and disturbance signal are carrier frequency, burst length and duty cycle.


The data signal should fullfill the following condition:

• Carrier frequency should be close to 38kHz.


• Burst length should be 10 cycles/burst or longer.


• After each burst which is between 10 cycles and 70 cycles a gap time of at least 14 cycles is neccessary.


• For each burst which is longer than 1.8ms a corresponding gap time is necessary at some time in the data stream. This gap time should be at least 4 times longer than the burst.


• Up to 800 short bursts per second can be received continuously


China Photo Mosfet Power Module PCM Remote Control Systems Output Active Low supplier

Photo Mosfet Power Module PCM Remote Control Systems Output Active Low

Inquiry Cart 0