

Add to Cart
Wall Angle Roll Forming Machine
Technical Parameter
Material of coil | Material Thickness | 0.4-0.8 mm galvanized sheet G550 |
Forming system | Rolling Speed | About 20 m/min line speed |
Roller Stations | About 9 stations | |
Roller Material | 45# Steel with quenching 60mm shaft | |
Maim Motor Power | 5.5 kw | |
Hydraulic cutting Power | 4 kw | |
Cuttingsystem | Material Of Cutting | CR12 with quench treatment |
Hardness | HRC58-62 | |
Tolerance | +-1.5mm | |
Electrical control system | Electric Source | 380V, 50HZ,3 phase Also can satisfy Customer’s require |
Control System | PLC control system | |
Weight | About 2.5 tons | |
Way Of Drive | 1 inch single chain | |
Size of machine | Length 4500mm* Width 500mm* Height 800m |
Work Flow Chart
Decoiler—feedingwithguide—Rollforming——Cutting—Products collecting
Machine Components
3 ton passive de-coiler | 1 set |
Main roll forming machine | 1 set |
PLC Control box | 1 unit |
Hydraulic station | 1 unit |
Out table | 2 units |
Following cutting | 1 unit |
Safety cover | 1 unit |
Machine Photo