

Add to Cart
PRODUCT DESCRIPTION
Let me introduce the product DZ-138B to you, which is able to be widely use for expressway toll station, bus station, shopping mall, airport, hospital and so on. It adopts third-generation servo motor, which uses international leading technology integrated design, mold manufacturing, compact structure, high precision, high consistency and standardization, planetary reducer transmission, high efficiency, long life, no oil leakage, no blockage , low noise and other characteristics.
PRODUCT PARAMETER
Product size | 292x368x9450mm |
Working temperature | -35℃~+65℃ |
Power supply | AC100V~240V |
Running speed | 0.2s~8s; |
Rated power | 750W |
Driving method | Servo motor |
Humidity | ≤90% |
Remote control distance | ≤100m(open & sunny weather) |
Protection class | IP54 |
Motor no-load speed | 5000r/min |
Adaptable boom length | 1.5m~2m; 3m |
PRODUCT FUNCTIONS AND FEATURES
1. Operation speed can be adjusted.
2. Slow up and slow down can be adjusted.
3. The limit angle can be adjusted.
4. Left and right direction can be quickly interchanged.
5. The barrier arm can be manually operated in case of power
failure.
6. 418 frequency learning code anti-copy remote controller.
7. Infrared photocell sensor I/O signal input function.
8. Loop detector and radar I/O signal anti-collision signal input
function.
9. Up, down and stop I/O signal input function.
10. Counting (fleet) function.
11.LED light I/O signal output function.
12.Traffic light I/O signal output function.
13.Up and down in place, normally open and normally closed signal
output function.
14.RS485 communication output function.
15.Delay arm drop function.
16.Arm auto-reverse function.
17.Automatic lifting function when power is off (requires
additional power storage module).
18.I/O port single-key cycle up and down function.
19. Loop detector normally open and normally closed function.
20.One car passes through each signal to prevent toll evasion
function.
21.Anti-collision alarm function (requires additional alarm and
sensor).
22. Fire linkage signal input function.
23.The I/O port closes the signal input function.
24.24V storage battery input function.
Electrical installation, wiring diagram
1. The internal wiring of this machine has been completed when it
leaves the factory, please do not change it, just connect the
220V(some countries 110V) power supply and the protective ground
wire to work.
2. Traffic light interface: 2a24v voltage traffic light use.
3. Infrared anti-smashing interface: External infrared
anti-radiation device, and the switch signal of the anti-radiation
output can be connected.
4. Ground sense(loop detector) interface: Support external ground
sense. When using an external ground sensor, you only need to
connect the switch signal output by the ground sensor.
5. Parking system interface wire control interface: Connect the
switch signal from the system