Add to Cart
UL817 Cable Testing Equipment Abrupt Pull Test Apparatus With 6 Working Stations
UL817:
96.4 Each molded-on representative device is to be secured in the
jaws of the flexing machine so that the point of cord exit is at
the center of rotation. The rotating jaws are to be adjusted to
rotate to an angle of 90° to each side of the centered position. At
the centered position, the cord is to hang vertically and the
weight, selected in accordance with 96.3, attached to each cord
approximately 1 2 inches (305 mm) from the point of rotation. See
Figure 96.1 .
96.5 Each representative device is to be subjected to complete
flexing cycles until a conductor in each device has opened (as
determined by a continuously-monitoring detection circuit), or
until 2,500 cycles is reached, whichever comes first. A flexing
cycle consists of: rotation of the jaws from the vertical
(centered) position until 90° to one side, back past the vertical
position until 90° to the other side, and back to the vertical
(centered) position. The rate of testing shall be 1 0 cycles per
minute.
Description:
This device is used for the resistance abrupt pull test of Plug of plug power line, torsion test, load test and grounding current test.
According to the standard UL817 clause 96.4-96.5 Flexing test, clause 99.1-99.2 Abrupt Pull Test, clause 100.1-100.3 Jacket retention test.
Test sample: Plug power line.
Feature: Using automatic mode test, it will automatic shutdown when reach to the setting number if test times or setting time.
Technical parameters:
Power supply | AC 220V 50Hz |
Load current | 0~40A , Arbitrary adjustable |
Load voltage | 4~12V |
Working station | 6 stations |
Test times | 1~9999 times, can be preset |
Test time | 0.1~999.9S |
Load weight | 2.5 pound(lb) , 3 pound(lb) , 15 pound(lb) 6 pcs per each |
Ambient temperature | 0~40℃ |
Ambient humidity | less than 85%Rh |
Reference standard | UL817 clause 96.4-96.5 Flexing test, clause 99.1-99.2 Abrupt Pull Test, clause 100.1-100.3 Jacket retention test |