1 meter to 6 meters Car Park Barrier Systems 4S For Parking Lot
Brand Name:WONSUN
Certification:CE, ISO, SGS
Model Number:DZTP-139-B
Minimum Order Quantity:1PC
Delivery Time:3-7 working days after received your payment
Payment Terms:T/T,Western Union,Money Gram, Trade Assurance,Paypal etc.,
Contact Now
Add to Cart
Verified Supplier
Location:
Shenzhen Guangdong China
Address:
1st Floor, Zhigu, No. 2-10, South jinlong Avenue, Shahu Community, Biling Street, Pingshan District, Shenzhen, China
Supplier`s last login times:
within 25 hours
Product Details
Company Profile
Product Details
1 meter to 6 meters Car Park Barrier Systems 4S For Parking Lot
What is the davantages of Wonsun barriers?
1)The humanized clutch device:in case of power off, unlock the clutch device and raise the boom manufally. By the time the power is supplied, lick the clutch device to make it working normally again.
2)Special spring device:Both the compression spring and tension spring can be used in the machine, Using the compression sprin can avoid accidents caused by the tension spring.
3)Three control buttons:for boom raising, falling and pausing.
4)Boom backtrack function:the boom will rise if hits something when falling.
5)Infrared photocell design:for avoiding the crash when the boom falling, so as to prevent the vehicles from being pressed.
6)Both external and internal loop detectors are supported.
7)"open","close" and "stop" controlling interfaces.
8)RS-485 communication serial interface(optional)
9)Traffic light signal connection device: red light for stop,green light for pass.
10)Remote control and wire control for selection.
Model Selection and Differences
| Boom type | Boom Length(L) | Diameter of the spring(mm) | Note | |
| Straight boom | 6M≥L≥5M | 5.5/4.5 | ||
| 5M≥L≥4.5M | 5.5 | Dispatching 4.5 | ||
| 4.5M≥L≥3M | 4.5 | Dispatching 4.5 | ||
| Straight boom adhesive tape | 5M≥L≥4M | 4.5M≥L≥3M | 5.5/4.5 | Dispatching 4.5 |
| 4M≥L≥3M | 3.5M≥L≥3M | 4.5 | Dispatching 4.5 | |
| Folding boom | 6M≥L≥5M | 6.5/4.5 | ||
| 5M≥L≥4M | 5.5/4.5 | |||
| 4M≥L≥3M | 4.5 | |||
| Two fence boom | 5M≥L≥4M | 6.5/5.5 | ||
| Fence boom | 4M≥L≥3M | 5.5/4.5 | ||
| Three fence boom | 4M≥L≥3M | 6.5/5.5 | ||
| 3M≥L≥2M | 5.5/4.5 | |||
Specifications
Model | DZTP-139-B |
Working Temperature | -40℃～+75℃ |
Voltage | 220V±10%, 110V±10%, 50/60HZ |
Rated power | 80W |
Relative humidity | ≤90% |
Remote control distance | ≥30m |
Net weight | 48kgs |
Speed | 1S,1.8S,3S, 6S |
Max boom length | 6 meters |
Motor Rotational speed | 1400rmp |
Protection Degree | IP54 |
Advanced Features:
1)clutch key can be used to open the clutch when power off.
2)Fan cooling machine reduce the motor temperature by high
frequency using, never get heat-protecting, unique temperature
calefaction design for low temperature using, prevent freezing in
cold weather.
3)Exactitude aluminium alloy die-casting motor base reduce the
noise and joint abrasion to prolong the barrier gate working life.
Communication with customers
1) Q: Connected power and press open/close button but traffic
barrier gate no action?
A | Reason | Solution |
1 | Fuse blown | Check fuse and power in controller |
2 | Battery of remote control powered off | Change a new one |
3 | External protection circuit break or at protecting status | Open the barrier door and click OPEN/CLOSE button on control box |
4 | Same frequency interference | Check photocell and loop detector |
2) Q:Connected power and press open/close button,traffic barrier
gate will move but even when it is at right position, the motor
still running and not stop?
A | Reason | Solution |
1 | Limit switch | Adjust the horizontal/vertical limit switch to correct position |
2 | Main controller failure | Change a new one |
3) Q: Motor running but traffic barrier gate arm no action?
A | Reason | Solution |
1 | Barrier arm at 45° position where is hard to move | Unlock clutch and manually rotate arm to horizontal or vertical position then try again |
2 | Tension of balancing spring not suitable | Adjust spring exactly |
3 | Low working voltage | Check the voltage and power |
4) Q: When opening/closing,traffic barrier gate arm cannot reach
right position (90° vertical & 180° horizontal)?
A. | Reason | Solution |
1 | Length adjustment of connecting rod not correct | Open barrier door and unlock clutch to check when arm at 90° vertical position if the master rod covers slave one; when arm at 180° horizontal position if master rod and slave one are in the same straight line |
2 | Nuts on the limit switch loose | Tighten the nuts when arm at 90° vertical and 180° horizontal position |
Why choose us?
1. OEM Brand, Logo, Label available
2. 1 Year Standard Warranty, excellent after-sales service
3. 24h*7d at your service to give you best support
4. Detailed installation manual and wiring diagram to make
everything be easy
5. Fast finishing time for you to become more competitive at your
local market :3-5 days for small order.
Contact us for pricelist and catalog:
Sue Zhang
Email:sue@wonsunbarrier.com
Skype:SueZhang729
Whatsapp:+86 158 7925 9831
1 meter to 6 meters Car Park Barrier Systems 4S For Parking Lot
Inquiry Cart
0