Add to Cart
HXE- Small copper wire drawing machine with Annealer & Double spoolers
I. Quick Description
Small copper wire drawing machine with annealer & double spoolers is used to draw and annealing single bare copper wire from 0.8mm-1.4mm to 0.1mm-0.6mm.
II. Main Technical parameters
1. Usage single bare copper wire drawing and annealing
2. Inlet size Ф0.8mm-Ф1.4mm
3. Outlet size Ф0.1mm-Ф0.6mm
4. Machine speed/max 1500m/min
5. Die number 22, Dies size 25mm×8-10mmT, Slip ratio 15.5%+8%
6. Wire drawing mode standing-mode and 4axes
7. Drive: by Inverter control, Brand Inovance, Chinese famous brand.
8. Main motor 15KW, Spooler motor 5.5KW*1set/2sets
9. Annealing voltage DC55V/max
10. Annealing current DC600A/max
11. Annealing power 33KVA
12. Annealing method D.C three-section annealer
13. Quantity of steam 8kg/h
14. Capacity of compressed air 0.4-0.6Mpa,15L/min
15. Demand Water quantity for annealing and coolant 150L/min
16. Machine frame welded by steel plate
17. Transmission By Timing belts
18. Capstan ceramic plasma
19. Lubricating system Spray
20. Bobbin size 300mm, loading capacity :50kg/max (Can be customized)
21. Bobbin loading &unloading type shaft type
22. Traversing unit 110W synchros motor, width: 270mm/max
23. Bobbin controlling Fixed by Screw
24. Brake 20KG-M magnetic brake
25. Operation panel &control cabinet 1000×800×1800mm
26. Machine dimension 2100mm*1600mm*1700mm
27. Machine weight 3200KG
III. Components
Name | Quantity | |
1. Pay-off shelf | 1 set | |
2. HXE-22DT Drawing&Annealing machine | 1 set | |
3. Electrical control system | 1 set | |
4. Steam generator | 1 set | |
5. Lubrication Tank and Pump | Optional | |
6. Spare parts | As per List | |
7. Operation Manual, Inverter Manual |
IV. Shipping & Installation
Shipping
There are two lifting rings on the drawing machine, four on then annealing machine.
Installation (See attached drawing)
According to the drawing, make the foundation.
When machine is in position, install bolts and adjust the center line.
When concrete is drying, adjust center line again and fix the bolts.
Adjust
Before adjusting, check and clean all parts.
V. Machine maintenance and precautions
1. Make sure the machine and the capstans clean, no scrap, no break wire.
2. Make sure the Take-up part clean.
3. Electrical cabinet should be closed.
4. Change belts if worn out.
5. Only qualified electrical technician can repair the electrical part.
6. Never change the Inverter parameter.
7. If something wrong with the machine that can`t solve, please contact the supplier first.
Do not open the machine without consulting to the supplier.
8. Put lubrication oil to the parts regularly, to make sure all parts running fluently. After running 1000 hours, clean all the bearings.
9. Annealed nickel belt and Annealing carbon brush are consuming parts. If spark happens a lot on the annealing capstans, then should change the nickel belt. If the carbon is going to run out, then need to change a new set.