10 Hz MediaTek MT 329 GPS Module With Antenna
The state-of-the-art 66 channels MediaTek MT3329 GPS Engine.
High sensitivity: Up to -165dBm tracking, superior urban
USB/ UART/ RS232 Interface.
Build-in patch antenna for optimal sensitivity.
DGPS(WAAS, EGNOS, MSAS) support (optional by firmware).
Maximum update rate : up to 10Hz (optional by firmware).
Note that the new MediaTek has custom and exclusive firmware that
allows the unit to output an efficient and very compressed binary
protocol (This firmware will only work with this kinds of
modules!). You can still change between NMEA and Binary protocol
with standard MTK messages, and switch the refresh rate between 1hz
to 10hz, or set any standard serial baud rate (by default is set to
38400 bps and custom binary protocol).
Arduino example for decoding the custom binary protocol is
provided. Remember to install the library folder "GPS_MTK" inside
the Arduino IDE "libraries" folder "arduino-00XXlibraries". For the
most updated code, please go to this page.
Once there, download the most recent "ArduPlane X.XX.zip" file;
open the "libraries" folder and then "AP_GPS" where you'll find the
most recent code.
1,Support fast TTFF function.
2,Based on MediaTek Single Chip Architecture.
3,Dimension:16mm x 16mm x 6mm.
4,L1 Frequency, C/A code, 66 channels.
5,High Sensitivity:Up to -165dBm tracking, superior urban
6,Position Accuracy:< 3m CEP (50%) without SA (horizontal).
7,Cold Start is under 35 seconds (Typical).
8,Warm Start is under 34 seconds (Typical).
9,Hot Start is under 1 second (Typical).
10,Low Power Consumption:48mA @ acquisition, 37mA @ tracking.
11,Low shut-down current consumption:15uA, typical.
12,DGPS(WAAS, EGNOS, MSAS) support (optional by firmware).
13,Support USB/ UART/ RS232 Interface.
14,Support AGPS function (Offline mode : EPO valid up to 14 days).
15,Includes a molex cable adapter, 5 cm!! (EM-406/uBlox Adapter
16,Includes the new basic adapter!! (Mediatek Adapter Basic).
17,Weight: 8 g.