Dual ES-16 Advanced HHO System
Double Stack Output for Large Engines
As a system, this ES-16 unit is a double stack of the ES-8 cell and
plenty formidable. Heavy duty all the way with electronics, tanks,
hose and hardware to make you confident with your application.
We designed the ES-16 unit with 12 inch plates for heavy duty
applications. By heavy duty we mean high levels of HHO output, but
also very long duty life for commercial applications. The stainless
plates are 16 gauge stainless steel, and the unit weighs well over
50 pounds when installed.
And for commercial applications, the tank is 2.5 gallons, not
quarts, along with our triple dryer system to keep your equipment
running efficiently and safely.
Its baseline production is 4 liters per minute. You can see there
is plenty of room to increase output, but also recognize this is
easily enough for engines up to 16 liters.
Large tractor trailers usually have engines larger than 9 liters,
and usually between 12 and 14 liters. The ES-16 is a long lasting
unit that can run at 100 amps as needed, but usually only requires
60 to do its job.We also pair it with our custom 100-amp Dual PWM that is virtually
maintenance free. Set the desired current draw, and you can run
this unit 24 hours, 7 days a week. This unit can be specified for
24 volt systems for no extra cost. Please contact us for more
- 1 x Double Stack 12" x 12" x 5" HHO Dry Cell Generator (13 plates).
This cell weighs 29 lbs without electrolyte.
- Pulse-Width Modulator (PWM). Our PWM comes with a remote display
unit that you can mount in the passenger compartment that will show
you your amp draw, pulse frequency, and duty cycle (the percentage
of the time that the voltage is high vs the time the voltage is low
during each pulse).
- Electronic Enhancer needed for your vehicle.
- 2.5 Gallon electrolyte reservoir with cap and fittings.
- Advanced Dryer Assembly
- 25' of heavy-duty 3/8" hose.
- 25' each of red and black 4 gauge wire.
- PWM Installation PanelIncludes all of the components of your PWM
system are pre-built onto a panel that you can easily mount on the
front of your cell, ready to connect to your Display/Controller in
- System installation kitIncludes all the connectors, screws, check
valves, drain valve, etc that you need to complete a full
installation of your system
Helping You Succeed
Advanced HHO offers parts along with selling entire kits. This
allows you to buy replacement items, or only order the harder to
find components you need to build your own. Please see the other
items we list.
The purpose of this system is encouraging the wide spread use of
alternative fuels. Hydrogen plays an important role in abundant,
safe energy for each of us, and the world at large.
This unit is ready to install per the safety specifications of the
plans. Comes with an Installation Overview and Diagrams.
Enjoy your purchase and we encourage
your feedback and comments!