... changing formations 3. Tri Cones are reasonably priced, long lasting and have an efficient rate 4. The roller cones have high end sealed ...
Add to Cart
...Tri Cone suitable for any rock formation is versatile and can handle changing formations Tri Cones are reasonably priced, long lasting ...
Add to Cart
..., also known as TCI Rotary and Roller Cone , are special mining used for oi...
Add to Cart
..., another tooth contacts the bottom of the hole and generates new rock debris, thus the process is continuous. High quality tungsten carbide blade ...
Add to Cart
...prevent getting clogged with material as they cut through the surface material. Tungsten carbide insert (TCI) are used for medium and ...
Add to Cart
... essentially consist of 3 roller cones having steel teeth or tungsten carbide inserts. Tungsten Carbide Insert (TCI) are are used middle ...
Add to Cart
20 (508mm) Long Life Span Rock for oil wells and coal mining *, *::before, *::after {box-sizing: border-box;}* {margin:...
Add to Cart
... 17 1/2" is almost the biggest in water well , usually small capacity rig can only drive 17 1/2" to 100-150 meters...
Add to Cart
... the bottom of the hole, the rock breaking torque is small, the contact area between the cutting teeth and the bottom hole is small, the specific p...
Add to Cart
... Teeth) can load a higher WOB in normal RPM condition. It applies in different formation from very soft to very hard matched with different cu...
Add to Cart
... 3 inch for well JSBIT factory offers all kinds of . Tricone bits are available in new an...
Add to Cart
12 1/4" Mill Tooth Rig / Roll Forged Commodity Size IADC Thread Connection WOB (Weight On ) RPM Formation 12...
Add to Cart
... Roller Air Bearing Mining Roller Cone Roller Rock 6 12 14 5 12 This series are non-sealed Roller Bearing b...
Add to Cart
API sealed bearing Milled tooth rock and steel drill tunsten carbide for water well Application 14inch API Sealed Steel Tooth ...
Add to Cart
... For Oil Platforms And Mining Roller Describe The is an ideal solution for transitioning from sof...
Add to Cart
... And Pipe Description of crossover sub Crossover sub is mainly used to connect upper and lower tools in different conn...
Add to Cart
... : 6 5/8 inch API REG PIN Nozzle : three jet (side) nozzles SIZE AVAILABLE From 3 7/8inch to 36inch RECOMMENDED PARAMETERS FOR APPLICATION...
Add to Cart
.../ milled tooth / roller cone / rock / TC TCI series: Soft formation TCI tricon...
Add to Cart
...be widely used for Oil&Gas ,Mining,Water Well,Geological Exploration areas.Our divideds into metal sealed and rubber ...
Add to Cart
... 1. The angle of the PDC cutter is 13-16°,which makes the have stronger aggressivity and higher ratory speed. 2....
Add to Cart