Lithium Iron Phosphate Telecom Battery 48V 40Ah 3U Rack With RS 485 Communication

Lithium Iron Phosphate Telecom Battery 48V 40Ah 3U Rack With RS 485 Communication

1. General Information

This specification defines the performance of rechargeable LiFePO4 battery pack TB4840F -T110D manufactured by TOPBAND NEW ENERGY CO.,LTD, describes the type, performance, technical characteristics, warning and caution of the battery pack.

2. Battery Specification(@ 25±5℃)

3. Electrical Characteristics & Test Condition

Testing Conditions: Ambient Temperature: 25±5℃; Huminity:45%~75%.

Normal charge:Charge battery under CC(0.33C)/CV(58.4V) mode until over charge protection or the charge current reduce to 0.05C, and then rest for 1h.

3. Circuit Protection

The batteries are supplied with a LiFePO4 Battery Management System (BMS)that can monitor and optimized each single prismatic cell during charge & discharge, to protect the battery pack overcharge, over discharge, short circuit. Overall, the BMS helps to ensure safe and accurate running.

5. User guide

5.1 TB48XXF-T110X Operation principle and Wiring hint

Input 220Vac, after rectification power module, output 48V. When the power grid normal, the battery will supply power according to system requirement, and to be charged at same time; when power off, the battery will supply energy, to make sure the DC power system working normally, to realize uninterruptible power supply. The power supply has second disconnection function, when the battery voltage is low, the battery output would be cut off to protect battery life.

5.2 Operation panel direction

Reset RS485 RS232 Dial switch RUN LED alarm LED SOC LED

5.3 sleep mode

The system would go into low-consumption mode in any of the following conditions:

1. Single module or the whole system over discharge protection not recovered in 30s
2. Press the keys for 3s
3. The minimum single voltage lower than sleep voltage and the lasting time reach sleep delay time (no communication, no protection, no balance, and no current at same time).
4. Standby more than 24h ( no communication, no charge or discharge, no AC input).
5. Force shutdown through upper-computer software.

Before sleep mode, please make sure there is no input voltage, otherwise it can no go to sleep mode.

5.4 wake up

When the system is in low-consumption mode, the system would exit low-consumption mode and go into normal running mode in any of the following conditions:

1. Connect to charger, and the charger output is more than 48V.
2. Press the keys for 3s
3. Connect to communication cable, open upper computer software( if it goes to sleep mode due to over discharge protection, this method would not wake up the circuit board).

Remark: single model or the whole system goes to low-consumption mode after over discharge protection, it would be wake-up every 4hs, to open discharge MOS. If it can be charged, it would exit sleep mode and start normal charge; if it fails to be charged after 10times of wake-up automatically, there would be no automatic wake-up.

5.5 Installation drawing

Case dimension: 482(Width) *445(Depth) * 130(height) mm；

Handle Depth:35mm; weight:Approx.27kg.

5.6 Transport & Store

The battery need to be charged every 6 months if out of use

No fall down, no pile up over 6 layers, and keep face up.

5.7 Warning & Tips.

Please read and follow the handling instructions before use. Improper use may cause heat, fire, rupture, and damage or capacity deterioration of the battery. TOPBAND NEW ENERGY CO.,LTD. Describes is not responsible for any accidents caused by the usage without following our handling instructions.

Warning

* Battery must be far away from heat source, high voltage, and no exposed in sunshine for long time.

* Never throw the battery into water or fire;

* Never reverse two electrodes when use the battery;

* Never connect the positive and negative of battery with metal;

* Never knock, throw or trample the battery;

* Never disassemble the battery without manufacturer's permission and guidance.

Never use mixed with other type of battery;

Tips

* Keep the battery against high temperature. Otherwise it will cause battery heat, get into fire or lose some function and reduce the life.

* When battery run out of power, please charge your battery timely (≤15day).

* Please use the matched or suggested charger for this battery.

* If battery emit peculiar smell, heating, distortion or appear any abnormity, please stop using.

* If the battery leaks and get into the eyes or skin, do not wipe, instead, rinse it with clean water and see doctor immediately.

* Please far away from children or pets.

* It is strictly prohibited any series between the battery packs. Any requirements on serials connection, please contact TOPBAND for details.

Shenzhen Topband Co., Ltd. was registered in so-called “China Silicon Valley”, Shenzhen Hi-tech Industrial Park in 1996, and got listed in Shenzhen Stock Exchange ( the stock code as 002139) in 2007.

After years of rapid development, now Topband takes lithium battery as the core technology and has become one of the leading suppliers of lithium battery solutions in China, focusing on nano lithium iron phosphate/ LiFePO4 technology for EV, RV/ caravan, marine, motorcycle, golf cart / trolly, UPS, solar storage, medical, floor scrubber, industrial, commercial use, etc.

Topband has more than 5000 staffs, covers an area of 100,000 square meters. And large production plants are mainly located at Shenzhen and Huizhou

Our R&D team of over 300 professionals, in cooperation with Tsinghua Research Institute and Harbin Industrial University have laid a firm foundation of our leading technology.

We have got the certificates of ISO9001, ISO14001, OHSAS18001, TS16949 and UL, CE, CB, UN38.3, TUV, etc.

Topband is a Hi-tech enterprise. Since the company established, with innovation, we have committed ourselves to making people’s lives more comfortable and high-efficient. We and our companions are working hard at making technology progress to let people enjoy the changes of new technology.