Self Locking Toilet Water Tank Fill Valve PP Material With Installed In Any Angles

Water tank fittings water valve, toilet water tank installation water valve

What is the cause of the water leakage valve in the toilet?

Cook inlet valve is actually the reason for the floating ball insensitive lifting work, can not guarantee normal complete row need water, the water or cannot control the water inlet valve, water supply, water kept in more than water tank of water, causing water above the forward drain valve nozzle flow into the urinal, even will flow to the ground.It is found that such problems need to be overhauled and replaced with water inlet valve accessories.Wan master below small make up teach you a economic and affordable toilet fill valve leakage disassembly maintenance, flush toilet water inlet valve not only repair methods, and explain the principle of the toilet water inlet valve can be better understand the repair process.

Leakage of the water valve in the toilet is not limited to water removal and maintenance steps:

1. Remove the inlet valve of the blue integral on the left side.(if the water inlet valve is leaking)

2. Take off the toilet water valve cap.

3. Remove the part of the white link point above the inner part.

4. Separate the two parts and remove them counterclockwise, with the help of small pliers.It's going to be clockwise, so you can put it on.

5. This part of the pipe is the key.

6. Install the transparent rubber ring and install it properly. If the installation is incorrect, the transparent rubber ring can not be screwed up.

7. Then connect the other parts.

8. This part of the bottom can be broken down again. If you don't pass the water, it is here.To try it, use the shower head in the bathroom and take it down to the bottom of the fill valve.

9. Turn on the shower switch and water.Lifting the float, the water stopped and the proof was fixed.Originally in the toilet, the inside float to bring up the water also can not stop.

Principle of water stop water valve of flush toilet:

1. When the water is released, pull the water knob and the knob will go through the lever.So the water in the tank will come out.When the water is released, the drain plug falls, blocking the outlet.At this point, the float also falls on the surface, at the bottom of the tank.The drop of the float pushes the lever into the water and the water into the tank.As the surface of the water rises, the floating ball will gradually rise due to buoyancy until the water pressure is pushed down through the lever to plug the inlet.The tank is filled with water.

2. When the inlet pipe is leaking due to failure (e.g. the water inlet plug cannot stop the water inlet or the water pipe burst), the water surface in the water tank will continue to rise and eventually overflow the tank.This problem is solved by the setting of water permeable pipe.When the water level rises to the opening of the water seepage, the water will flow from the seepage into the toilet and will not overflow the water tank.When the water pipe is working normally, the water in the water tank will not reach the water seepage, so there is no need to worry about the water flowing away.

Xiamen MuRuJia CO., LTD., founded in 2015,we are one professional company who supplies all kinds of bathroom products,like Toilet Tank Fittings,Toilet Seat Covers,Plastic & Brass Bidets, SS Bidets,Hand Shower ,RainShower and Shower Kits,Brass & Plastic Faucets,SS/PVC Shower Hoses,all kinds of Drainer Pipes,Plumbing Rubber & Seal,Installation Screws.Our products are covering all over the world!

Welcome to visit our company.

Hopefully we will have chance to serve you the best.