Theft Prevention Obd Gps Car Tracker Small Obd2 Mileage Tracker 70*55*25cm

Dimension

70*55*25cm

Working Voltage

9-36V DC

Average Current

130mA@12V

Sleeping Current

3mA@12V

Working Temperature

-30℃∼+70℃

Storage Temperature

-40℃∼+85℃

Positioning Accuracy

<10m

GPS Frequency Range

1575.42MHZ

Frequency Range Including

FDD LTE: B1/B3

TDD LTE: B38/B39/B40/B41

TD-SCDMA: B34/B39

WCDMA: B1

CDMA2000 1x/EVDO: BC0

GSM: 900/1800MHz

WIFI Frequency Range

2400-2485M

OBD

Support OBD II / EOBD

4G Antenna

Built-in

GPS Antenna

Built-in

WIFI Antenna

Built-in

Communication management function

Letter of agreement

The data information interacts with the platform using the TCP protocol. The IP address, port number, and APN are directly set to the terminal through the platform, and password protection is provided.

GPS Location

Positioning data

Including latitude and longitude, time, satellite number, speed, direction, ACC status, battery voltage, OBD speed, also includes network base station LAC and CellID information, operator code, the terminal automatically determines the trajectory route and realizes intelligent reporting of GPS points.

Reminder alarm function

Alarm

Ignition reminder
Flameout reminder
Vehicle low voltage alarm
Idle speed alarm
Water temperature alarm
Speed alarm
Collision alarm
Trailer alarm
Fatigue driving reminder
Device insertion alarm
Long positioning time alarm

Driving behavior

1. Driving behavior

2. Driving behavior event

1. Including driving cycle start terminal time, driving cycle total mileage, average speed, maximum speed, over speed duration, over speed times, idle duration, rapid acceleration, rapid deceleration, sharp turn information.

2. During the running of the vehicle, sudden acceleration, sudden deceleration, and sharp turn events are generated, and the incident is reported separately.

OBD data function

Read and clear vehicle failure

The key data of the vehicle is reported every 30S. The number of specific data items is slightly different according to the support data of the vehicle. The terminal identifies the vehicle fault information. When the vehicle fault status changes, it reports to the platform. When the fault is found, the vehicle sends a command to clear the vehicle fault.

Remote control management function

Remote setting

The platform remotely sets terminal information, vehicle type, GPRS communication parameters, heartbeat parameters, GPS/CAN return parameters, clear vehicle faults, control restart, factory reset, clear blind zone data, various alarm parameters, and rapid acceleration and deceleration through the mobile network. Sharp turn parameters.