Add to Cart
Tattoo and spot removal ND YAG Laser Machine / yag laser tattoo removal machine
Application:
1. Removal tattoo, eyeliner, eye brow, remove black, red, blue, all
kinds of color pigment
2. Remove dermis spot, fleck, black nevus, age pigment, birthmark
and Nevus of Ota
3. The 1064nm wavelength mainly for black, blue, cyan pigment
4. The 532nm wavelength mainly for red, coffee, brown pigment
Advantage:
1. Truly portable, continent
2. New-developed hand piece
3. Infrared ray aiming
4. Water-flow monitor
5. Water flow and temp monitor
6. Plug and play functione and meet the continuously long time work
of machine.
Specification
Laser type | Q-Switched ND:YAG |
Cooling manner | Closed-off water circulation + air |
Laser wave length | 1064nm/532nm |
Black moppet wave length | 1320nm |
Single pulse energy | ≤200mj 1064nm |
Spot diameter | 1-5mm |
Pulse width | 10-20ns |
Working frequency | 1-6HZ |
Remove Red Base | 532nm crystal |
Remove Black Base | 1064nm crystal |
Cooperate with carbon Powder,tender & whitening | 1320nm Black Moppet Head |
Application:
Treatment course for different illness case as follows:
Treatments Treatment course required ( cure times) Treatment course
interval Remark (requirements in surgery)
eyebrow-embroidery(eyeliner grain), 1 –2 times, 30-60 days, Eyebrow
blow, eyeball protection
Eyebrow-embroidery ( eyeliner embroidery), 1-3 times, 45-60 days,
Eyebrow blow, eyeball protection
Lip line (red dyed lip), 1-3 times, 15-45 days, Use 532nm filter
Tattoo(caused by extraneous wounds), 1-4 times, 30-60 days, Blood
infiltration will be fine on wounds
Freckle, age spot, 1-4 times, 15-30 days, Blood infiltration will
be fine on wounds
Birthmark, nevus/mole, 3-7 times, 45-90 days Must have Blood
infiltration.
(1) Treatment for tattoo in eyebrow
Customer could not open eyes during treatment, operator should
adjust energy according to depth of tattoo color, hold the handle
and move it to treatment area slowly to make customer feel
acceptable in mentally. Right now, the speed of flash could be set
3HZ, keep head of the handle a two-finger distance to treatment
area, start treatment from head of eyebrow to end of eyebrow. It is
needed to treat again in 5-10 minutes if the color of tattoo
re-appear.
(2) Remove eye line
The speed of flashes could be set 4-5HZ,adjust the energy of light
to minimum energy, keep a one-finger distance between head of
handle and treatment area. Operator should strictly protect
customers’ eyes with panel for eyelid or medical pledget (panel for
eyelid)of 1cm depth.
Treatment should be started from down eye line, customer should
deeply close eyes and keep eyeball up-sight inside. Operator should
press the pledget (panel for eyelid) with forefinger and push up
eyelid, peel down eyelid with middle finger to bare the eye line,
treat it with flashes of 4-5Hz. Then, treat up eye line. Also
customer should close eyes and keep eyeball down-sight inside.
Operator should press the pledget (panel for eyelid) with middle
finger and push eyelid down, push eyelid up with forefinger to bare
the eye line, treat it with flashes of 4-5Hz.
(3) Remove lip line
The speed of flashes could be set 5Hz,keep a 3/4 finger distance
between head of handle and treatment area. It is better to remove
black, coffee, deep, red and brown lip line with 1064nm head at
first time and then, treat again with 532 nm head.
Notice: All tattoos in lip should be treated in 6 months after
making. OR removal treatment will fail. It should have 45-60 days
interval to continue next treatment until remove all.
(4) Remove tattoo
The speed of flashes could be set 3Hz/5Hz.It is better to use high
energy for treatment until treatment area seeps a little blood. It
should have 45-90 days interval to continue next treatment until
remove all.
(5) Remove spot and nevus
The speed of flashes could be set 3Hz/5Hz.Keep 3-4 fingers distance
between head of handle and treatment area. It is better to use high
energy for treatment until treatment area seeps a little blood. It
is advised to use 1064 nm head for normal spot and nevus treatment,
but for deep color spot and nevus, it is better to use 532nm head
for treatment. It should have a 15-30days interval to continue next
treatment until remove all.
(6) Remove birthmark
The speed of flashes could be set 3Hz/5Hz.It is better to use high
energy for treatment until treatment area seeps a little blood. It
is advised to use 1064nm head for birthmark treatment, but for red
and deep color birthmark, it is better to use 532nm head for
treatment. It should have 45-90 days interval to continue
What is the treatment Principle?
1. Adopting the Q-Switched ND:YAG model,the equipment uses laser to
emit high energy instantaneously which smashing the pigment of
pathological tissues,namely the laser leading explosive effect:High
energy emits instantaneously,making particular wavelength laser
penetrating epidermis and getting into pathological pigment tissues
in only 6nms.Then pigments expand in top speed and explode.The
superficial epidermis would be bounded out of body;other part of
the pigments would split into granules which would be engulfed by
macrophages,then exclude by the lymphatic system finally.The
pigment becomes shallow gradually finally disappear while the
surrounding normal skin tissues keep sound as they do not absorb
particular wavelength laser.