2-Concern of safty and development
4-Leading in China
Why choose SHENGWEI?
1-We are a Chinese specialized supplier of thermal oil/fluid
heaters. We have been engaged in this field for 18 years, we can
design the individual scheme for you in accordance with your fuel
and special requirements, our product have a capacity range from
0.1M Kcal/hr to 20M Kcal/hr.
We pay close attention to every detail and we are to make them with
the highest quality all over the world.
2-We can supply you the most leading thermal oil heaters in China,
and the best cost performance all over the world.
3-We persist the enterprises concept of innovation and team work,
we pay more attention to every detail, after all these years, every
small part is composed of our wisdom and everlasting study, we hold
more than 50 patents, and have a outstanding performance in the
energy-saving and environment protection.
We introduced the converter technique into our electric control
We design and manufacture the first Circulating Fluidized Bed
Combustion Thermal Oil Heater all over the world.
4-Through constant international cooperation about technique and
experience, our manufactures have a leading quality and superior
specifications. To optimize your energy solution is our eternal
Rice husk fired thermal oil heater is a mature branch of our
products. We have supplied many of this kind of heaters for several
Southeast countries like Malaysia, Thailand etc,
The Natural Gas and/or diesel fired heaters are very popular in the
Middle East countries, Africa countries, north Europe countries,
South Korea and Japan are most important of our overseas market.
5-We have a overseas market in Southeast Asia, Middle east, East
Asia, Egypt and South American countries like Chile and Peru, more
than 50 countries have our thermal fluid heaters, all of them with
little fault rate and we earns good remark and many potential
Why choose thermal fluid heater?
The choice between a steam system or a thermal fluid system is
governed by the process requirements. The range or process
temperature is a deciding factor. If the systems required
temperature is above the freezing point of water (32°F) and below
approximately 350°F, the choice is usually steam. However, if the
required temperature is below 32°F or above 350°F, thermal fluid
may be a better solution.
Reliability and rugged long life construction ;
Guarantee on both the burner and the boiler ;
Efficiency, which can be higher than 92% over the operating range ;
Investments and maintenance costs reduced ;
Optimised heat balance, associates the high output of the boiler
with very low thermal losses on the distribution system which means
very high overall plant efficiency ;
Very short response time, low inertia ;
Optimisation of the thermal coefficient of transfer of the boundary
Low pressure of operation normally no more than total system
resistance (10 bar max) for high temperature (350°C) ;
Well suited for indirect process heating;
Safety of the whole system by the installation of dedicated
controls and equipment to suit the process requirements
(deaerators, temperature monitors and alarms, deaerator relay...) ;
No corrosion, therefore, very long plant life.