QC11Y-12x2500 Hydraulic Guillotine Shearing Machine
Shearing thickness (mm)
Shearing width (mm)
Cutting plate tensile strength N/mm
Shearing angle (°)
Back gauge range (mm)
Blade length (mm)
Throat depth (mm)
Main motor power (KW)
Oil pump( L/min)
Variable Rake Angle Design Machines.
Motorized Rake angle adjustment.
Low noise & smooth operation gives higher efficiency of
Less power consumption.
Better safety for operator and machine.
Front sheet support.
Squaring arm with steel rule for front gauging.
Hardened Transfer bars mounted on table.
Hold down cylinders.
Foot pedal with emergency stop
Strokes can be controlled according different shearing length
Four edge 6CrWi2Si Blade suitable to MS & SS.
Stroke counting on screen.
Fast production on smaller jobs.
Construction of the machine
The stable frame consists of the following elements:
A bottom table with the beam shaped steel blocks and the lower
An assembled upper part with the plate holder;
The two uprights connect the two stationary parts (the bottom table
and the upper part), the jointing parts are welded to enlarge the
stability of the machine.
The cutting beam
The up-and down moving part of the machine is called the cutting
beam. The cutting beam is a steel welded structure, with high
rigidity and stability. The movement is obtained by two hydraulic
cylinders. The cutting beam is guided by special roll bearings,
three roller bearings to fix the cutting beam to let it move up and
down vertically in high precisions.
The oil tanker& The cylinders
The oil tanker is at the top of the machine, connected to the two
uprights. The oil-level can be checked by looking through the sight
glass. The oil-level glass must be filled almost to the maximum
level. Different oil qualities should never be mixed, as this may
set off a chemical reaction.
The hydraulic cylinder mounted on the top of the frame, the piston
is connected to the cutting beam driving the beam and delivering
the rated cutting force power.
The cylinder housing is made of cast iron or steel. The hardened
and ground piston is guided on synthetic slides. The piston is
connected to the cutting beam by means of a hinge joint.
The hydraulic system
The hydraulic group is situated at the top of the oil tanker and
connected to the other part by flexible high pressure hoses and a
multi-signal electrical connection. The unit consists of one main
pump for pressing action, combined with an oil tank and filter
All hydraulic pipes and hoses are suitable length and be mounted
onto the mechanical structure with sufficient and adequate clamping
devices. All connections are (easy) accessible and tested for
leakage. Hoses are kept clear of edges to avoid unnecessary wear.
The front gauge and support arms
The front gauge shows the exact measure of the plate on the working
table. When the plate is pressed to the cam, the measure can be
read on the removable rule between the gauge and